2811 strip with iss...
 
Notifications
Clear all

2811 strip with issues.

9 Posts
5 Users
0 Reactions
3,020 Views
scottmcm
Posts: 621
Topic starter
(@scottmcm)
Prominent Member
Joined: 19 years ago
[#34876]

Has any one seen this? I just hooked up this new strip and everything from pixel 11 on was dark. I bumped it and 11 to the end flashed. I started looking at 10 and found this inside the tube.
It is two little "hairs", one on the led and one on the ic. When they move they short the circuit and cause downstream craziness. I am going to carefully extract them and see what happens...


8 Replies
scottmcm
Posts: 621
Topic starter
(@scottmcm)
Prominent Member
Joined: 19 years ago

Hairs removed. Now if I turn on all white I see that 11 on are still dark and 10 is slightly blue. (All three leds) If I gently squeeze the tube by the IC on 10 the rest of the strip will light but will not take any more commands unless I squeeze it again. I turned on all green with the same results except that after the little squeeze when the rest of the strip came on they were blue. Should I just go ahead and extract this pixel and replace? Thanks.


Reply
Robo
Posts: 1494
 Robo
(@robo)
Noble Member
Joined: 14 years ago

Damn, why are pixels so delicate! Is there such a thing as commercial grade pixels. Sorry for hijacking but I feel your pain..
Looks like some Ramen noodles got in there during production.


Reply
scottmcm
Posts: 621
Topic starter
(@scottmcm)
Prominent Member
Joined: 19 years ago

Lol. Commercial grade probably costs more than $ 20 or so per 5 meters. I bought this one on ebay a few months ago and should have tested it then....


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Here you go: http://www.stellascapes.com/

from MPH/mrpackethead here on DIYC.


Reply
Page 1 / 2
Share: