2811 strip with iss...
 
Notifications
Clear all

2811 strip with issues.

9 Posts
5 Users
0 Reactions
3,021 Views
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

Still made in China and look very familiar


Reply
Posts: 2128
(@livermore-dad)
Famed Member
Joined: 16 years ago
scottmcm wrote:Lol. Commercial grade probably costs more than $ 20 or so per 5 meters. I bought this one on ebay a few months ago and should have tested it then....

$20.00 w0w, I know my 5meter are $40 *ink1003/2812b or whatever*. I would like a more commercial product that is fully enclosed in epoxy (but then repairs are not as easy..

Just can't believe they can call the weatherproof pixels from aliepress, Ray Wu, IP68, no way!

Tory


Reply
Robo
Posts: 1494
 Robo
(@robo)
Noble Member
Joined: 14 years ago
budude wrote:Here you go: http://www.stellascapes.com/

from MPH/mrpackethead here on DIYC.

NOW were talking. Just ordered 50Meters


Reply
scottmcm
Posts: 621
Topic starter
(@scottmcm)
Prominent Member
Joined: 19 years ago

It just keeps getting better....after removing the hairs carefully did not work, I decided to be a little more aggressive and managed to get them out even from under the IC and led. This fixed the color problem and I thought it was going to work...but then everything after 10 went off....then on...then changed color...then off. Every time I touched the strip it would do something different so there was obviously a bad connection. I tapped various components until I realized that the three resistors by each led were all loose. I did a terrible job of reflowing the first one but found some skills on the 2nd two. Powered it back up and woohoo! they are all on and all the same color! I dropped down the color selector and chose blue to see that the other colors worked. Well, the first section of pixels all lit blue, then the second and third sections lit green. Crap. These sections were from different spools and it turns out some are RGB and some are RBG (or something). I think I can correct that in Vixen (I hope) since the prop is 42 pixels with 17 blue and 25 green right now....sheesh, these HOs are never going to get done! Then I decided to leave the strip on and tap/squeeze all the way around to make sure there were no other loose connections....all seem good...


Reply
Page 2 / 2
Share: