Great work Scott. What are the resistors on the outputs? 33ohm? I noticed that I can get longer cable lengths with your controllers with 33ohm. Sent ...
dkulp wrote:Scott also just updated the kicad files and such to use the proper i2c2 pins. Thus, if anyone is thinking of ordering boards, grab the ne...
Success? looks like it.
dkulp wrote:If you are using the FPP 5.0 branch, you can try doing an update and seeing if it will allow you to flash the eeprom on i2c1. (and then ...
Dan, So the solder bridge would be on the P9 side?
dkulp wrote:Actually, looks at Scotts KiCad stuff, it looks like the I2C things are on the wrong pins. He put them on pins 17/18 but the I2C pins we...
dkulp wrote:Actually, looks at Scotts KiCad stuff, it looks like the I2C things are on the wrong pins. He put them on pins 17/18 but the I2C pins we...
dkulp wrote:Nothing is detected... is the OLED plugged in? That should be there as well at 0x3c. Double check the soldering around everything on t...
Thanks Dan. You are right, no eeprom detected. 🙁
jllracer55 wrote:I am just curious to hear if anyone has had any of Scott's boards produced recently at a fab house?? If so, which one did you use and...
ukdel wrote:There was a discussion around this.. Post #228 in this thread says... I just tried it too and it doesn't seem to work. If you upgrade to ...
Hey Derek, I messed around quite a bit with this and the best I could do was get the cape identified. I could not burn the eeprom to the board. Burned...
ukdel wrote:Hi Scott kindly produced a bin file for the BBB16 eeprom. I got it from the issues folder (you need to look in the closed issues) in the g...
I built a BBB16 and have PB16 boards coming. Everything seems to be working just fine. I haven't been able to load the eeprom.bin file. It's in the fo...
DrNeutron wrote:I used digikey, but to save on the BOM I bought the pixel connectors on aliexpress for much much cheaper (3, 2 and 4 pin). This way I ...
