FPP PB16 Pixel Cont...
 
Notifications
Clear all

FPP PB16 Pixel Controller

630 Posts
62 Users
6 Reactions
389.5 K Views
Posts: 115
(@strawberry)
Estimable Member
Joined: 11 years ago

I've ordered the BBB 16 expansion it seems there's a conflict with 1 part per Jlcpcb support.
Soldering issue of J6, the spacing between pins in gerber file is 5mm, while the part C69811 is 3.81mm pins, so it can't match the pads in gerber file.

Sent from my SM-G960U using Tapatalk


Reply
Posts: 544
(@jllracer55)
Honorable Member
Joined: 13 years ago

I am just curious to know.. If there is a source that has pocket beagles back in stock in larger QTY yet or if the one off lucky in stock locations that list these for double what I paid last year is all there is right now? Several locations show they will not have stock until almost the end of November of 2022, Anyone else found anywhere that shows an in stock date that is way earlier than this?? Also, has anyone loaded the most recent FPP onto their SD card and been successful at it working on the PB16 boards?? I never could seem to get my first build to work.. so haven't even tried builds 3/4, even though I would like to.


Reply
rayhjr
Posts: 972
(@rayhjr)
Noble Member
Joined: 12 years ago

https://www.digikey.com/en/products/detail/beagleboard-by-seeed-studio/102110561/15929657
696 in stock
I have had no problem in th past with fpp but have not tried lately.


Reply
Posts: 544
(@jllracer55)
Honorable Member
Joined: 13 years ago
rayhjr wrote: https://www.digikey.com/en/products/detail/beagleboard-by-seeed-studio/102110561/15929657
696 in stock
I have had no problem in th past with fpp but have not tried lately.

Thanks Ray! I had issues with the PB16 not sending any pixel data out the outputs, and I could not figure out why. Unfortunately I had to finally just give up trying and scrap trying to use it and haven't had a chance to put the board back on my work bench/table and try to trouble shoot further. But I was going to consider upgrading to the latest FPP on it and see what that did when I get a chance, but wanted to know if it worked ok for others or not and how much different the configuration settings are to get it setup correctly as I know a lot has changed compared to the version that is on the micro SD card that is currently in the pocket beagle.


Reply
rayhjr
Posts: 972
(@rayhjr)
Noble Member
Joined: 12 years ago

I would be more than happy to help you with it when you get ready to start on it.
If you are using Xlights the set up is a snap. If your controller with fpp is set up, just turn it on and go to Xlights controller tab. If the phone handle in bottom right corner is green then Xlights can see your fpp controller and all you have to do is hit the Upload button. That's it. It just sent youe Xlights configuration to your controller. Click the Open tab and it will open your fpp conrtoller. Go to the Input/Output tab and go to outputs, under that you will see Pixel strings under outputs, to start with but when you upload the Eprom file it will show PB16, click on that and you will see your setup. Make sure the Enabled box is checked at the top of the page.
If you don't use Xlights you'll just have to set it up manually. That's about it. Feel free to PM me anytime for help on this. Ray.


Reply
Page 96 / 126
Share: