If you use the expansion boards with my controllers you get the power of FPP. They can not be daisy chained, they have to be plugged in individually. FPP supports all three Receiver modes, "Dumb", Smart V1, and Smart V2. Each port can do 1400 pixels at 20fps or 800 pixels at 40fps. I have started updated all my boards to support different voltage regulators, I may also design a little switcher board to fit the controllers.
Scott
Strawberry wrote:scooter_seh thanks for the clarification, I wasn't sure . I was thinking of using the Falcon v3 expansion boards since they are available and would work with the legacy Diff receivers. I don't need to chain 6 receivers.
I like the idea of plugging in 3 expansion boards, you can mix and match to what is needed. Can the BBB cape/hat be powered solely by using the barrel connector, since the voltage regulators are unavailable?In this configuration, using 3 expansion boards with 3 ribbon cables would the max pixels per port be 1024?
or could you daisy chain the expansion boards?
I like this design, it can be configured to use 48 ports in any combination of expansion boards.
Are you going to populate the files for this to be built? If so I will build some.
Also where can I get the ribbon cables?
Sent from my SM-G960U using Tapatalk
Strawberry wrote:I like this design, it can be configured to use 48 ports in any combination of expansion boards.
Are you going to populate the files for this to be built? If so I will build some.Also where can I get the ribbon cables?
Sent from my SM-G960U using Tapatalk
When you get the boards, I'll buy a couple of them from you if you're interested. I don't really need 5 but a couple would be nice. Pm me if you want.
rayhjr wrote:When you get the boards, I'll buy a couple of them from you if you're interested. I don't really need 5 but a couple would be nice. Pm me if you want.
Hopefully all the smd chips are available when I order, I'm not sure if there are substitutes available.
I noticed there's a voltage regulator on the board, is it needed if I'm using the barrel connector for power on the BBB?
Sent from my SM-G960U using Tapatalk
Strawberry wrote:Hopefully all the smd chips are available when I order, I'm not sure if there are substitutes available.
I noticed there's a voltage regulator on the board, is it needed if I'm using the barrel connector for power on the BBB?Sent from my SM-G960U using Tapatalk
I guess Scott could better answer that question but if you're only using board for Data output then probably you could power the bbb with barrel connector and not need the regulator. I have always populated the board and use board power weather just using data or actually powering the pixels from the board. But then that was years ago when there were no chip shortages.
