stenersonj wrote: Our light show is cleaning out our building and we have some controllers we would like to sell. We are mainly pixels and static LEDs...
ErnieHorning wrote: If your target is simply under $1 each, Novelty Lights looks like a solid choice, especially if you need enough to hit their quant...
Besides plasma bringing fourth a solution, did you find any good pricing from a vendor? I have been looking and looking and can't seem to strike much ...
iflights wrote: I just checked and must have thrown them out already. Sorry to get any hopes up. Bummer!! Anyone else??
tfischer wrote: Honestly I think your best bet at this point would be to snip the ends off and start switching things over to xConnect. There was nev...
superdave wrote: The longer DIY is gone, the harder it is getting to find. A couple vendors have dropped the compatible cables. It looks like you c...
iflights wrote: I may have extensions and pigtails if you need them. I think I will need some extensions for sure, probably pigtails too, Send me a ...
algerdes wrote: How long do you need? At this point I will take what I can get, Ill put some together end to end if I need to, to get the proper len...
tfischer wrote: So... any more word on this forum possibly continuing vs dying off? I was just sitting here late into the morning wondering the same...
teberle wrote: What are you asking for then and do they work? Are you still looking for Renard controllers?
I know this is an old post, but I thought I would attempt to bring it back to life by seeing if there was any other alternative besides the wiredwatts...
dirknerkle wrote: the old DIGWDF Store has a page of firmware, too. I actually re-downloaded everything there so if it ever disappears I still ha...
Would you have any interest in having a spare?
olingerjccj wrote: Yes the top 2 plastic pins pulled out, the bottom 4 are still connected. I am concerned if I bend it back the bottom pins will brea...
