FPP PB16 Pixel Cont...
 
Notifications
Clear all

FPP PB16 Pixel Controller

630 Posts
62 Users
6 Reactions
389.5 K Views
Posts: 115
(@strawberry)
Estimable Member
Joined: 11 years ago
BBB Expansion test

I was wondering if this is correct how I'm thinking the expansion boards will function. #1 is in dumb mode, #2 is V2 smart mode, #3 is V4 smart mode. Can all 3 versions work on the same expansion card?

BBB Expansion test

Reply
Posts: 544
(@jllracer55)
Honorable Member
Joined: 13 years ago
rayhjr wrote:I would be more than happy to help you with it when you get ready to start on it.
If you are using Xlights the set up is a snap. If your controller with fpp is set up, just turn it on and go to Xlights controller tab. If the phone handle in bottom right corner is green then Xlights can see your fpp controller and all you have to do is hit the Upload button. That's it. It just sent youe Xlights configuration to your controller. Click the Open tab and it will open your fpp conrtoller. Go to the Input/Output tab and go to outputs, under that you will see Pixel strings under outputs, to start with but when you upload the Eprom file it will show PB16, click on that and you will see your setup. Make sure the Enabled box is checked at the top of the page.
If you don't use Xlights you'll just have to set it up manually. That's about it. Feel free to PM me anytime for help on this. Ray.

Thanks Ray, I have 1 built , with 2 more on stand by/partially built (missing a few components is all) I don't recall what I was using at the time for a test, I believe I used xlights because the test feature makes it so quick but because I use traditional LED lights and pixels I use Vixen to sequence from. I think my biggest disconnect was between the mapping in fpp and xlights more than likely, but I do appreciate any help and time you offer up to help me get it figured out with hopes to run these boards in 2022.

Sent from my SM-A716U using Tapatalk


Reply
Posts: 115
(@strawberry)
Estimable Member
Joined: 11 years ago

I built a diff expansion, when plugged in the black chip heats up. Is this normal?
I'm running it with the BBB16 expansion v1.

Sent from my SM-G960U using Tapatalk


Reply
DrNeutron
Posts: 2017
(@drneutron)
Noble Member
Joined: 14 years ago

I haven't built any of these yet, but I would reflow that 120ohm resistor and the caps just to be safe.
Hopefully a few of the guys who built these will speak up if this normal or not.


Reply
Posts: 115
(@strawberry)
Estimable Member
Joined: 11 years ago

I reflow the solder and it still makes heat.
It possibly could be the Bbb16 expansion.

With 3 diff expansion boards plugged in, the on-board 5v buck converter is undersized, it causes the BBB to have low power. I'm using a 5v 350w PS now , which has solved the low power issue.

Sent from my SM-G960U using Tapatalk


Reply
Page 97 / 126
Share: