I have mostly Pixabulbs, going on 10 years old. I lose about 5-6 each year. it's always water intrusion that kills them. I have plenty of spares. I h...
I'd put a 10 watt RGB spotlight in that. That's what I do with my inflatables.
I do this for 3 different set of props for my show. I'm backfeeding power (12v) to my Komby wireless controllersthrough about 50 pixels . Been doing ...
Well that Stinks. I have 2 FM25B's and they have been rock solid for me
I can confirm that "LOR DMX" is standard DMX. On the older controllers, the pin-out is different, that's it. On some of the newer controllers, LOR ha...
I have those Holiday Coro Modules in my large Inflatable snowman. They are waterproof. Have been use for 2 seasons and did not loose any pixels. Ti...
You can make that out of an old string of lights and some heat shrink tubing.
I use Pixabulbs on my house and Minitrees. I haven't done anything to them. Question, Are you supporting the bulbs with anything on your MegaTree ?...
I use a Komby RF1 (with no radio installed) with a USB battery. load a simple sketch that puts out 170 pixels of data changing color. The USB 5v batt...
I used to have this issue when I used incandecent mini lights. Once I switched to sealed commercial LED's the problem is gone. Tim
If its simple DMX, not E1.31 , then this works great. Only supports ws2801 and ws2811 I have a few of them myself. Shows in stock, and is in th...
This year's new song for me is Uptown Funk, I can't tell you how many hours I have into it. Every year I add 1 New Christmas song and 1 New Rock song...
This Light is a DMX controlled fixture. In order to use it you need to send it DMX commands via Serial (typically RS485) You can configure one of the...
If you do not have a LOR dongle attached to the computer, then make sure you go into the network preferences "LOR" tab and set it to NONE . If you hav...
from my testing with a raspberry Pi and 5V pixels using USB batteries, I would say it will run a very long time. I ran 50 Pixels ,the Pi and a Komby R...
