Pixel Waterproofing
 
Notifications
Clear all

Pixel Waterproofing

8 Posts
6 Users
0 Reactions
2,556 Views
Posts: 322
Topic starter
(@rklarman)
Reputable Member
Joined: 18 years ago
[#39508]

I have quite a few pixels that go bad due to moisture. I am working with GECEs and pixabulbs. I think that water gets into the pixels through the wire openings in the sides of the green connectors. Especially on the pixabulbs where the opening is meant for 4 wires yet only uses 3 wires.

What are people doing to waterproof (or re-waterproof) their pixels? We have two pixel mega trees and the strings are mounted vertically (as usual) which puts the top wire input in direct line of any rain or melting snow.

Can the bases be dipped in a coating or are people injecting silicone directly into the openings?

Sent from my iPad using Tapatalk


7 Replies
Posts: 70
(@timbenson)
Trusted Member
Joined: 13 years ago

I use Pixabulbs on my house and Minitrees. I haven't done anything to them.
Question, Are you supporting the bulbs with anything on your MegaTree ? like Strips or guide wires or Pipe ?

If you are not supporting them with anything , then I could see the wire flexing at the point where it enters the sealed part of the pixabulb and causing a breach in the
seal of the bulb.

If you actually wanted to add more sealant, you probably would need to dis-assemble each bulb and add more sealer to the base of the inner assembly (where the wires enter the Epoxy)

Tim


Reply
Posts: 322
Topic starter
(@rklarman)
Reputable Member
Joined: 18 years ago

The bulbs are attached to strips so there isn't much weight being placed on each pixel. There have been 7-8 failed pixabulbs this year - out of 600. They were fine their first year - I think there was one that failed towards the end of the season

Sent from my iPhone using Tapatalk


Reply
komby
Posts: 871
(@komby)
Prominent Member
Joined: 14 years ago

I had a lot of failed pixels last year and some that are extremely prone to water ingress(walmart). I determined this year my only choice was to slather them with silicon. I use GE Silicon II. for each pixel i remove the bulb covering, I coat the area around the pixel with silicon, i dip the cover in silicon and re-attach, then i rub silicon on the entry and exit wires. its annoying and its a time sink but hopefully i wont be cutting out as many pixels this year.

Its going to rain today, we will see how good of a job it does.

Im using technicolors, walmart pixels and homemade plasma icicles


Reply
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

Pixabulbs most likely aren't getting water in. That green part is a shell...Peel it off and you'll see a pcb fully encapaulated in resin. I had some Pixabulbs fail too...but they had stuck leds

Sent from my LG-H811 using Tapatalk


Reply
Page 1 / 2
Share: