Pixel Waterproofing
 
Notifications
Clear all

Pixel Waterproofing

8 Posts
6 Users
0 Reactions
2,557 Views
jklingert
Posts: 1767
(@jklingert)
Noble Member
Joined: 16 years ago
rklarman wrote:There have been 7-8 failed pixabulbs this year - out of 600.

Less than 2% failure rate over two years is pretty good. Back just 3 years ago people saw much higher failure rates. The wiki has some ideas how people tried to enhance the waterproofing.


Reply
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

Yeah...I'd say that was good

Sent from my LG-H811 using Tapatalk


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

I've had a very low failure rate with pixabulbs. I've replaced 4 or 5 in total. And some are on their 3rd year. I lost track of how many I have in total but it's somewhere around 1000. I've never seen any condensation or signs of water under the lenses of the bad pixabulbs. The failure mode with these is either missing color or no data passthru. Both symptoms would come and self heal with weather. I attribute these failures to bad solder joints.
Totally different story with GECEs. Those definitely have water intrusion problems. The GECEs aren't completely encapsulated. There a clamshell style plastic that's sealed around the edge with thermoplastic. Every one of those failed GECEs had signs of condensation under the lens. I think my failure rate with them was over 5%. The worst were the ones used in a bulb up configuration. I've since sold all of those off. (Yep, the same ones I bought from you)

--Jon Chuchla--

Sent from my iPhone using Tapatalk


Reply
Page 2 / 2
Share: