Cold Weather Questi...
 
Notifications
Clear all

Cold Weather Question

5 Posts
3 Users
0 Reactions
1,459 Views
Posts: 347
Topic starter
(@dougd)
Reputable Member
Joined: 19 years ago
[#39506]

Need a super genius to help me out with this.

I put 160 2811 pixels on some mini trees using a 682 controller. First pixel is about 15 feet away from the controller.

Set this prop up about a month ago and for 3 weeks prop was working perfect. We have had a mild fall here weather never getting below 50 degrees I think. 3 days before going live weather dipped down into the thirty's and the mini trees started staying on white while testing, an apparent data problem. I was going to work on them on Thanksgiving but by then the weather had warmed up and the trees were working perfectly. Went live on Friday, trees have worked perfect ever since, weather has been in 60's and 70's. Last night it got back down to low 40's upper 30's and the darn things are staying white again.

I will put in a null pixel and hopefully that will solve my problems. I just have never seen this behavior in pixels before.

I know all about heat and cold effects on things, but seriously, is that what is going on here.

Anyone else had this problem before?


4 Replies
Posts: 347
Topic starter
(@dougd)
Reputable Member
Joined: 19 years ago

After doing this post I start reading the following. Should have done a search first. When this problem started a week or so ago there was nothing on it.

http://doityourselfchristmas.com/forums/showthread.php?40962-My-Crazy-Pixel-Problem


Reply
jklingert
Posts: 1767
(@jklingert)
Noble Member
Joined: 16 years ago

Look at the obvious things affected by temperature change like connectors. Corrsion, moisture and bad connections are places I would start with.


Reply
Posts: 347
Topic starter
(@dougd)
Reputable Member
Joined: 19 years ago

Don't think it is moisture. It rained here for 4 straight days and trees worked fine. Wasn't until the rain stopped and the weather cooled down that the problem came back. These are brand new pixels, will check my connectors but it is a straight shot using pixel wire and then soldiered to a 2 pin connector. I will remove the connector and see what happens.


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

Cold can cause solder joints to contract and lose connectivity. Water can freeze in connectors and push them apart. I had a problem with my Cable drop to the house. Warm weather no problems, Cold weather loss of internet and tiling on the TV. Water had gotten into the drop and was freeing and thawing, causing problems.


Reply
Share: