DMX Issues
 
Notifications
Clear all

DMX Issues

5 Posts
4 Users
0 Reactions
2,460 Views
Posts: 2
Topic starter
(@hiliano)
New Member
Joined: 11 years ago
[#38481]

Hi everyone, I am trying to upgrade my lights this year into DMX. I've got a E386 and a fill strings of 2811, and here is my problems:

Step 1- Config E682 (PASS)
Step 2 - Open E682 config page and test the lights (PASS)
Step 3 - Connect E682 with LOR (PASS)
Step 4 - I can see that LOR is connected with E682 (PASS)
Step 5 - Make a small sequence to see the lights in action (Done)
Step 6 - IT DON'T WORK 🙁

I being trying and reading so many pages and videos and I can't figure this out. Please Please HELPPPP:whtf:


4 Replies
tucsonlights
Posts: 667
(@tucsonlights)
Honorable Member
Joined: 15 years ago
Hiliano wrote:Hi everyone, I am trying to upgrade my lights this year into DMX. I've got a E386 and a fill strings of 2811, and here is my problems:

Step 1- Config E682 (PASS)
Step 2 - Open E682 config page and test the lights (PASS)
Step 3 - Connect E682 with LOR (PASS)
Step 4 - I can see that LOR is connected with E682 (PASS)
Step 5 - Make a small sequence to see the lights in action (Done)
Step 6 - IT DON'T WORK 🙁

I being trying and reading so many pages and videos and I can't figure this out. Please Please HELPPPP:whtf:

I don't know a lot of LOR but make sure LOR is outputting e1.31 not dmx. On the config page are there any packets being sent?


Reply
Posts: 2229
(@plasmadrive)
Famed Member
Joined: 15 years ago
Hiliano wrote:Hi everyone, I am trying to upgrade my lights this year into DMX. I've got a E386 and a fill strings of 2811, and here is my problems:

Step 1- Config E682 (PASS)
Step 2 - Open E682 config page and test the lights (PASS)
Step 3 - Connect E682 with LOR (PASS)
Step 4 - I can see that LOR is connected with E682 (PASS)
Step 5 - Make a small sequence to see the lights in action (Done)
Step 6 - IT DON'T WORK 🙁

I being trying and reading so many pages and videos and I can't figure this out. Please Please HELPPPP:whtf:

How did you determine LOR was connected with the e682?
Also, what is your "Comm Listener port:" set to in the Network Configuration window?


Reply
Posts: 2
Topic starter
(@hiliano)
New Member
Joined: 11 years ago

yes it is


Reply
Posts: 70
(@timbenson)
Trusted Member
Joined: 13 years ago

If you do not have a LOR dongle attached to the computer, then make sure you go into the network preferences "LOR" tab and set it to NONE .
If you have a dongle defined in there, but don't have it attached, it will disable control lights.
OR make sure you have the LOR dongle plugged in and defined.

Also make sure you have the LOR control panel running, or it will not output E1.31


Reply
Share: