What to use for tes...
 
Notifications
Clear all

What to use for testing pixels?

14 Posts
8 Users
0 Reactions
4,477 Views
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago
[#39476]

Is there a way to test pixels without using a computer? I have both 5 and 12 volt pixels and I'm installing them for a project for next year. I just want to light them up and see if it's what I want but don't want the hassle of connecting to a computer.

Sent from my Nexus 7 using Tapatalk


13 Replies
DrNeutron
Posts: 2017
(@drneutron)
Noble Member
Joined: 14 years ago

I use the controllers built in testing routines.
You would still need to connect to the controllers to run the routines but most are web based so you could do from a tablet or phone.


Reply
Posts: 70
(@timbenson)
Trusted Member
Joined: 13 years ago

I use a Komby RF1 (with no radio installed) with a USB battery. load a simple sketch that puts out 170 pixels of data changing color.

The USB 5v battery has plenty of power (6600mAh) and lights the 12v pixels just fine.


Reply
Wolfie
Posts: 2225
(@wolfie)
Noble Member
Joined: 11 years ago

Actually, the j1sys P12 has a simple dip switch to put it in test mode. No need for a computer or any outside connection other than power. Its what I have been doing working on my star.

If you do have a PC, then this tool is a GREAT test tool. You can easily toggle specific colors, on/off, full white and even a chase test. Easy to set universe/pixel/board. FAR easier than using test sequences in Vixen.
http://www.da-share.com/software/da_e131/


Reply
stallionent
Posts: 1460
(@stallionent)
Noble Member
Joined: 13 years ago
Reply
Page 1 / 3
Share: