Pixel String Curren...
 
Notifications
Clear all

Pixel String Current Draw (WS2811 12volt 50 ct)

6 Posts
5 Users
0 Reactions
2,429 Views
Posts: 481
Topic starter
(@jukingeo)
Honorable Member
Joined: 17 years ago
[#39487]

Hello All,

I recently bought these strings from DIYLEDEXPRESS.com:

http://www.diyledexpress.com/index.php?main_page=product_info&cPath=42_44&products_id=267

There are 12 volts and 50 pixels to a string. Yet, no power figure is given. I know that being RGB there are 3 elements in each pixel and thus that would be 150 elements on a string of 50. So I am thinking that a single string is on the verge of pulling a good amount of current. The question is...how much current.

I thought I would come here and find a quick answer, but apparently searching for this didn't yield much. So I am curious as to what the current consumption is for a single string of these WS2811 pixels.

Any info would be appreciated.

Thank You,

Geo


5 Replies
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

20ma per led, so 60ma per pixel. This is ballpark. Most pixels of this type use these figures.


Reply
Posts: 1344
(@mrsmoofy)
Noble Member
Joined: 12 years ago
Skunberg wrote:20ma per led, so 60ma per pixel. This is ballpark. Most pixels of this type use these figures.

And this would be at ALL white.

If you have a meter you could test to see what it draws that's the only for sure way to know. I have found them to be different from different manufactures even though they are using the same components.


Reply
Wolfie
Posts: 2225
(@wolfie)
Noble Member
Joined: 11 years ago

Ray Wu lists 50ma. Others 60ma. So that puts the string of 50 somewhere between 2.5 and 3.0 amps.

Ray's store lists his at 0.6w, 50ma. Those figures do work out re ohms law. .6/12 = .05. I usually go on the worst figure, in this case 60ma, when planning things out. That way I know the cabling and PSU are capable. And its good to have a bit of headroom in case you need to throw some extra pixels in or you nick the wire when stripping insulation back.


Reply
Posts: 255
(@rogerh)
Reputable Member
Joined: 12 years ago

All those calculations for power usage look good on paper. One of the things that are dissapointing is the quality of the pixels from China. The wire thickness varies alot. Anywhere from 18ga down to 24 ga. As the guage wire gets thinner the voltage drop increases and the amps used is less. This gives you a false hope that you won't need much power injection. Don't be fooled, pull out the old jumper cables in the car trunk and you'll be good to go.


Reply
Page 1 / 2
Share: