Replaced power supply and they have not came back on yet... I had 2 in the box and replaced the 1 to the side that was coming on. Both showed 11vts bu...
Over voltage makes more sense being the controller works fine when data is sent to it. Hope that is it.
Will check voltage today, thanks for that.
Will a hard reset be done from the system command by going 10 then 20 then 30?
Thanks for that. Will fix that
Going to try a hard reset also.
Tomorrow going to try switching pixels from the other side of the board to the problem side and see what happens.
Just checked again and only 3 of the strips were on from 3 seperate ports of the same side of the board and went off in about 2 seconds then wait a fe...
Will post a screen shot shortly
Just ran a test sequence and all the colors and pixels work fine. Will leave it plugged up for a while and see if they come back on.
