Notifications
Clear all

E682 issue

19 Posts
6 Users
0 Reactions
4,516 Views
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

Looks like your start channels are all set to Channel 1. Also whatever end channel number is the next channel needs to start the next number. So, you have universe 1 starting channel at 1 and ending at 378. Then universe 2 needs to start channel 379. Technically you are can still use universe 1 as your starting universe on outputs 2-1 to 2-4 because a universe uses 510 channels. I did notice that you have a null pixel on output 2-1. That could effect things also. I noticed also that the controller is receiving packets for universe 5-12. Those universes aren't being used so not sure why packets are being sent to the controller.


Reply
Posts: 12
Topic starter
(@tebrigan)
Active Member
Joined: 9 years ago

Thanks for that. Will fix that


Reply
gassy
Posts: 548
(@gassy)
Honorable Member
Joined: 17 years ago

Do I understand this right - the lights are coming on with NO data and NO test patterns? Also, I believe your universe and channel numbers are OK.


Reply
Posts: 241
(@mrdudeman)
Reputable Member
Joined: 12 years ago

there is nothing wrong with his universes all starting at channel 1 because his universes are not overlapping.
as far as the network he is using.. that ip address range is the default network windows uses if his PC is set to get IP from DHCP and if his computer isnt able to contact a DHCP server. it should work fine but i wouldnt trust it. if he ever plugs it into a net that has a DHCP server then his IP will be different. recomend you/he set your network card to use a static IP of 10.0.0.200 or 192.168.1.200 but before you set it, change your 682 to use the new range. so if you wanna use 10.0.0.x set your 682 to 10.0.0.201
i dont think any of this has anything to do with his problem though. if you set a testpattern in the 682 then it will test all the lights whether its connected on the net or not.

however i have experienced unreliable test pattern behaviour when all outputs are using 11ish full universes. but in your case you arent using very many channels so you prob wont run into that issue.

hard to say what you should do next.. when you get the problem, unplug all lights from board and only use 1 string and try it in each output. if an output doesnt work, verify voltage at tje connector.. if voltage ok, try swapping the socketed driver chip associated to the connector with a neighboring chip from a good bank.


Reply
Posts: 138
(@brettjm)
Estimable Member
Joined: 13 years ago

I have heard of people having similar problems when their voltage is to high, 12.1, 12.2 or higher. Check the voltage coming off your power supply, try putting it to 11.8 or 11.9 volts to see if that helps.


Reply
Page 3 / 4
Share: