Activity
 
Notifications
Clear all
gassy
gassy
@gassy
Honorable Member
Joined: Jan 14, 2010
Topics: 87 / Replies: 461
Reply
RE: FPP does not read Sound Blaster P3

This thread might be worth reading over on the Falcon forum.

4 years ago
Reply
RE: FPP does not read Sound Blaster P3

This is usually caused by having an FM transmitter within a few feet of the SB3. Is this the case with you?

4 years ago
Reply
RE: Need help with output configuration

How about a screen shot of the FPP Output configuration.

4 years ago
Reply
RE: Direct Connection of SansDevices E6804 to stand alone (no internet) computer.

jukingeo wrote:Okay, so how do I go about doing this? Thanks Go to your computer's settings>network>ethernet>ip assignment> if it's set to DHCP cha...

4 years ago
Reply
RE: Direct Connection of SansDevices E6804 to stand alone (no internet) computer.

More than likely your computer's ip address is set by DHCP, you'll have to set a static (manual) ip address that's on the same subnet as your SanDevic...

4 years ago
Reply
RE: xLight sequence not playing in FPP

Did you render the sequence before uploading to the pi? A screen shot of your pi's e131 output configuration might be helpful.

4 years ago
Reply
RE: Pixels Staying On

Are you injecting power along the string? 400 pixels will have too much voltage drop without using power injection.

4 years ago
Reply
RE: K8-PB and Smart Differential Receiver Board - Only 2 Ports Light Up

First thing is to set the Smart Receiver in "normal" mode (Dumb Mode) if you haven't already done that. I'm not 100% sure, but I believe if you are no...

4 years ago
Reply
RE: Can you offset strands? Will xlights allow that?

I remember this being discussed a few years back. Not a 100% sure, but I believe they were taking their tree and creating a custom model with every ot...

4 years ago
Forum
Reply
RE: Renard ss8 Board with stuck on channel NEED HELP

Sounds like you covered everything. Maybe a second pair of eyes checking the solder joints would help. Post a focused picture of the back of the board...

4 years ago
Forum
Topic
Replies: 1
Views: 763
Reply
RE: Need help configuring a small "mega tree" in 2 Outputs

In xlights, what value did you put for #Strings nodes/string & strands/string?

4 years ago
Reply
RE: ip config problem on my SanDevices E682

Just not that one....it would be best to touch them all (re-flow). Make sure your iron is hot enough to get a quick flow

4 years ago
Reply
RE: ip config problem on my SanDevices E682

Whenever I had problems with mine it was always a poor solder connection or bridge....inspect all the solder points closely and re-flow them just in c...

4 years ago
Page 1 / 37
Share: