gassy
gassy
@gassy
Honorable Member
Joined: Jan 14, 2010
Topics: 87 / Replies: 461
Reply
5 years ago
Reply
RE: F/S; 2 Rasp Pi3 / 1 Rasp Pi2

Have a Pi3 still available, PM if interested.

5 years ago
Topic
Replies: 3
Views: 1536
Topic
Replies: 0
Views: 1189
Reply
RE: Mega Tree Help

techs21 wrote:Ok if I take the non working strand and move that to a working port the strand works fine, If I take the working stand and move it to th...

5 years ago
Forum
Reply
RE: Mega Tree Help

If it's not the controller or the lights, then you need to look at your output settings. Screenshots of your E682 Output settings and output settings ...

5 years ago
Forum
Reply
RE: 3 trees daisy chained and one not working

Do you have extension cables between the trees? If so, have you swapped them around?

5 years ago
Reply
RE: 2x2 Matrix Wiring with BBB with OctoScroller

Configuration will be easier if you use 2 outputs from the octoscroller. Run the second one to the lower right panel in the picture then the cable on ...

5 years ago
Reply
RE: FPP and Falcon Picap + Rasberry Pi 3 B+ not working in Test mode

Be sure that when you check enable that you hit the save button

5 years ago
Reply
RE: FPP and Falcon Picap + Rasberry Pi 3 B+ not working in Test mode

A screenshot of your output configuration page on the pi would be helpful.

5 years ago
Reply
RE: Strange Issue with Falcon Smart Receivers

More than likely it is the config setup....to me everything looks good on Falcon setup, how about some screenshots of your xLights setup? Controller s...

5 years ago
Reply
RE: Strange Issue with Falcon Smart Receivers

Any chance the smart receivers for port 35 (a,b & c) are sharing the same power supply? Also, you have lots of unused outputs, have you considered fin...

5 years ago
Reply
RE: Strange Issue with Falcon Smart Receivers

To be clear.....in the Falcon configuration you add one pixel (3 channels) to port 35a and you get no output on 35b and 35c. Remove the 1 pixel (3 cha...

5 years ago
Reply
RE: Strange Issue with Falcon Smart Receivers

A screen shot of your controller output page would be helpful. What happens to each of the props when you run test mode on each of the smart receiver...

5 years ago
Reply
RE: Stuck Pixels/Nodes

To eliminate voltage issues do a test with white and check the voltage at the end of string.

5 years ago
Page 2 / 37