Stuck Pixels/Nodes
 
Notifications
Clear all

Stuck Pixels/Nodes

8 Posts
2 Users
0 Reactions
1,800 Views
Posts: 11
Topic starter
(@ric878)
Active Member
Joined: 6 years ago
[#55033]

Hi Everyone,

So, I have my display pretty much ready for the season but I am having an issue with one of my props. I have a series of candy canes connected together. Each is made up of 100 12v bullet nodes so 300 total. They are connected to a 4-String Differential SmartReceiver Board. The first two light up and change per the sequence. The last one does, then does not. At first, it will light up and change per the sequence, but eventually, part of the candy cane gets "stuck". I stress that only part of it does, maybe the last 60-70 nodes. It will stop changing and just stay static with whatever was on display at the time it got stuck. It will stay like that indefinitely.

If I reboot the differential smart receiver, it starts working again, then after a few minutes, it gets stuck. I have checked all my settings and connections and I just can't figure it out. I was thinking that it could be a data loss issue but I wanted to check here first before I start doing anything drastic.

Setup:
1 x F16V3
1 x F16V3 Expansion Board
1 x F16V3 Differential Expansion Board
6 x 4-String Differential SmartReceiver Board

Thanks In Advance,
Ric


7 Replies
gassy
Posts: 548
(@gassy)
Honorable Member
Joined: 17 years ago

Try decreasing the brightness of the candy canes and see what happens. It could be a voltage drop issue.


Reply
Posts: 11
Topic starter
(@ric878)
Active Member
Joined: 6 years ago
gassy wrote:Try decreasing the brightness of the candy canes and see what happens. It could be a voltage drop issue.

I should have mentioned, I already have the brightness set at 35% for my entire display.

Sent from my iPhone using Tapatalk


Reply
gassy
Posts: 548
(@gassy)
Honorable Member
Joined: 17 years ago

To eliminate voltage issues do a test with white and check the voltage at the end of string.


Reply
Posts: 11
Topic starter
(@ric878)
Active Member
Joined: 6 years ago
MikeKrebs wrote:consistent spot? you have a flaky pixel.

Not really, it can be the last 50-70. Changes every time I restart the receiver.

Sent from my iPhone using Tapatalk


Reply
Posts: 11
Topic starter
(@ric878)
Active Member
Joined: 6 years ago
gassy wrote:To eliminate voltage issues do a test with white and check the voltage at the end of string.

I’ll try that tomorrow. Thanks.

Sent from my iPhone using Tapatalk


Reply
Posts: 11
Topic starter
(@ric878)
Active Member
Joined: 6 years ago
MikeKrebs wrote:swap 1 with 3. does it follow or stay?

Great suggestion. I just did the swap, problem does not follow, it stays.


Reply
Posts: 11
Topic starter
(@ric878)
Active Member
Joined: 6 years ago

Ultimately I resolved this by moving that last prop to a different output. I figured this would take care of any data issues and power issues simultaneously. Seems to be working fine now.


Reply
Share: