Hello All
I have a 16 strand Mega Tree that is 50 Pixel per strand, it is controlled by a san device E682
I am using 5v 2811 pixels
Everything works except 2 strands do not
I have tried a dirrferent controller still the same, I have tested the strands and they are working fine I get 2 white lights and one red and they do not go off at all
I have included 2 pictures showing the 2 strands next to each other not working
If it's not the controller or the lights, then you need to look at your output settings. Screenshots of your E682 Output settings and output settings of your sequencing software along with FPP outputs if your using it to control the E682
Double check your pixel per on your setup page, and universe start stop. Make sure they are configured properly with enough channels to go around.
Are you testing with the same wiring as is in the tree setup? maybe something in the pigtail or any connections. No Data, lack of V+ or V- .
Test full white and use a meter to check all voltages, including Data, at conection going into those 2 strings.
Also make sure the plugable connector at the board is in proper slots and pushed all the way in. I have pluged them in wrong and
messed thing up in the past myself. And inspect wiring on those 2 strings down where the problem is. Hope you find your problem soon.


