ip config problem o...
 
Notifications
Clear all

ip config problem on my SanDevices E682

10 Posts
5 Users
0 Reactions
1,881 Views
etterm
Posts: 48
Topic starter
(@etterm)
Trusted Member
Joined: 6 years ago
[#56116]

I have (2) E682's , both kits that I put together. I was able to connect to one of them and change the IP. I having problems with the 2nd one. I've done the trouble shooting tips from San Devices page and none of the force IP are working. I've run a diagnostic check and my computer sees the 2nd E682 but has trouble connecting to it. I've even used a 2nd computer to see if that maybe the problem. When I did over ride (1) , the red & green lights stay off , they don't flash the IP. They stay off until I disconnect power and the restart it again. All 7 LED's are on (5 on the board & the 2 on Ethernet jack.) I'm not sure if I am doing something wrong. Any help would be appreciated.


9 Replies
gassy
Posts: 548
(@gassy)
Honorable Member
Joined: 17 years ago

Whenever I had problems with mine it was always a poor solder connection or bridge....inspect all the solder points closely and re-flow them just in case.


Reply
Posts: 503
(@iflights)
Honorable Member
Joined: 14 years ago

If you take a really well focused picture of the top and bottom of the board and post it here we could get some additional eyes on it.


Reply
etterm
Posts: 48
Topic starter
(@etterm)
Trusted Member
Joined: 6 years ago
iflights wrote:If you take a really well focused picture of the top and bottom of the board and post it here we could get some additional eyes on it.

Thanks for the help


Reply
Posts: 752
(@popo-b-trippin)
Prominent Member
Joined: 13 years ago

The top side looks good, but when I zoom in on the bottom pic it's too blurry to see the solder joints... at least for me.


Reply
Page 1 / 2
Share: