I have swapped out 5v for 12v pixels on the first half of my controller. So I installed a 12v power supply. The other half was already 12v. With the newer v3’s there is only one power toggle and I understand that is mainly for selecting what the brains on the unit is run by. ( the power being supplied to powers 9-16.)
That is switched to 12v. And that side works fine. But the ports 1-8 do not. Nothing happens. The controller does show it is getting 12.0v. What an I missing. The ports do show there are programmed to output from them. I am lost.
Please post screen shots of the string configuration. Then a screen shot of the test page with the test output activated.
Are the LEDs next to the fuses for ports 1 - 8 lit?
I figured out the issue. It’s strange because I used these ports last year and did not rewire any ports this year. But the problem was the wiring of the pigtails were reversed (positive and ground). Controller gremlins at play to mess with my head. Lol. But seriously, I am so confused on how this was the case.
