Reduced to $29.00 Check eBay link.
Here’s what the mount looks like on the white YPS small enclosure.
I bought a YPS small enclosure mount from LipichEngineering on Etsy. Mount attaches to 2”x 2” square tubing. I used the hardware supplied with enclosu...
Added a 4” x 1/4” braided ground strap which goes between door & enclosure body. Ring on strap needs to be installed offset. It interfered with gasket...
Just an FYI. I weighed the enclosure (last picture from previous post) and it comes in at just a little under 16 pounds.
I got the pigtails wired in and they clear the door latch. I'm going to probably use Velcro cable ties to hold the pigtails in 2 groups of 8 just to h...
I just got the temperature controller wired up & mounted. Temp probe fits through one of the holes on power supply mount. I'll zip tie it to hold it i...
Added 2 circuit breakers and wiring to board. Circuit breakers might be over kill for protection but I don’t want to risk it. I should getting to the ...
szaske wrote: this looks great. I personally run to a plastic store (Tap Plastic) and buy scrap sheets of acrylic for like $1 a piece and just make my...
By these pictures you can how much material of the mount I removed (white circles in pictures.) The side mounting holes for the top power supply mount...
I bought the double stack , power supply mounting bracket from Your Pixel Store. I liked the staggered mounting of power supplies. I found out quickly...
MikeKrebs wrote:As for the color problems, you might be able to redeem with an aggressive curve on each color but I probably would just relegate them ...
