Notifications
Clear all

E682 issue

19 Posts
6 Users
0 Reactions
4,528 Views
Posts: 12
Topic starter
(@tebrigan)
Active Member
Joined: 9 years ago
[#46445]

plugged in one of my E682 with no data attached on ac power yesterday with pixels attached to each of the ports. came home last night and the pixels attached to one half of the board were coming on for a few seconds all in red then going back out. they wait a few seconds and repeat the same pattern. none on the other side of the board were on. both sides of the board powered by 1 12vt power supply running 4.051 firmware. I have 3 of these and the other 2 are fine. is this a firmware issue?

thank you


18 Replies
Posts: 241
(@mrdudeman)
Reputable Member
Joined: 12 years ago

i dont have an answer and dont know if this is related but..
i have a 682 powered by a 12vPS. half the board wont drive the lights. not even in testpattern mode. they were working at first but then stopped. verified 12v there at the stringConnectors. took board to work to scope out the dataline and both halves worked flawless. brought board back to the installation. the same half wouldnt work again. brought board to work to scope it again. flawless.

not sure whats up, wont find out anymore until the weekend. if you figure anything out with your problem please let us know cause im interested


Reply
duramadmax
Posts: 904
(@duramadmax)
Noble Member
Joined: 16 years ago

do you have a screen shot of setup screen...


Reply
Posts: 12
Topic starter
(@tebrigan)
Active Member
Joined: 9 years ago

Just ran a test sequence and all the colors and pixels work fine. Will leave it plugged up for a while and see if they come back on.


Reply
Posts: 12
Topic starter
(@tebrigan)
Active Member
Joined: 9 years ago

Will post a screen shot shortly


Reply
Page 1 / 4
Share: