tbm878
@tbm878
Trusted Member
Joined: Dec 17, 2017
Topics: 9 / Replies: 28
Reply
RE: Increase voltage at psu

The output current would be affected.... 12.0v & 29a 12.5v & 28a 13.0v & 26.9a 13.5v & 25.9a I (current) = P (watts) ÷ E (volts)

5 years ago
Topic
Replies: 13
Views: 3466
Reply
RE: Question on only using data from controller

P. Short wrote:In any case, is there any reason that this needs to be settled now? Let it simmer, things will probably become clearer with the passag...

5 years ago
Reply
RE: Question on only using data from controller

1pet2_9 wrote:That's why I propose to simplify it by not worrying about your data line. Unless you short data to ground, there is no safety issue th...

5 years ago
Reply
RE: Question on only using data from controller

I would like to make it simple, but at every turn it gets (i make it) more complex

5 years ago
Reply
RE: Question on only using data from controller

This is with 3 kulp 32 boards & 18 psu's

5 years ago
Reply
RE: Question on only using data from controller

P. Short wrote:Me, too. Without knowing what each those 53 18/3 cables are for, it's hard to know what to say. --12v power supplies, 200 pixels p...

5 years ago
Reply
RE: Question on only using data from controller

I understand most people use multiple control boxes at the various props. My thinking is that it would be simpler doing it in 1 big control box becau...

5 years ago
Reply
RE: Question on only using data from controller

OK, I guess I had misunderstood a couple things. So what would be the best way to do this with the least amount of cables needed? My control box i...

5 years ago
Reply
RE: Question on only using data from controller

Maybe this will help. The first option has me running a single 18-3 cable from the controller box to the first pixel. And not running a V- from the ...

5 years ago
Topic
Reply
RE: Kulp boards, increase the 5a fuse size

My initial reason for this was wanting to make sure i have everything setup & fused properly. It is reassuring knowing that the kulp boards can suppo...

5 years ago
Reply
RE: Kulp boards, increase the 5a fuse size

Thanks for the help & suggestions everyone. And thanks for the offer of 7.5a fuses, but i have a good stock of various sizes myself. Tim

5 years ago
Reply
RE: Kulp boards, increase the 5a fuse size

dkulp wrote:The traces are good for about 10A so the 7.5a fuses should be OK and still have plenty of head room. That said, as you note, the 30A scre...

5 years ago
Topic
Page 2 / 3