Question on only us...
 
Notifications
Clear all

Question on only using data from controller

36 Posts
8 Users
0 Reactions
5,963 Views
Posts: 339
(@heldwhat-christmas)
Reputable Member
Joined: 15 years ago
MartinMueller2003 wrote:I would say I disagree with this in a big way.

I should have said... You should connect up the V- as a best practice... It will probably work if you don't.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

As an electrical engineer, I will 100% agree with Martin. Don't be penny-wise, pound-foolish. Run the V- wire in close proximity to the data wire (the preferable location would be in a twisted pair with the data wire, although most people get away with ignoring this aspect), and keep the voltage drop in that particular V- wire to a minimum by not running actual pixel power through it.


Reply
Posts: 1420
(@1pet2-9)
Noble Member
Joined: 6 years ago

I think there is confusion in that the power injection V- lead on the first pixel and the V- on the Xconnect (or JST...whatever) are two pins to the same node. Yes, of course you connect the node. You just don't need to connect it twice.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago
1pet2_9 wrote:I think there is confusion in that the power injection V- lead on the first pixel and the V- on the Xconnect (or JST...whatever) are two pins to the same node. Yes, of course you connect the node. You just don't need to connect it twice.

If you are power injecting at the first pixel, then there are three V- wires being connected: PSU V-, Signal V-, Pixel V-


Reply
Posts: 1420
(@1pet2-9)
Noble Member
Joined: 6 years ago

You don't need to connect the pixel V- if you're already connecting direct to PSU.


Reply
Page 2 / 8
Share: