Espixelstick - Esp3...
 
Notifications
Clear all

Espixelstick - Esp32 - maximum led

23 Posts
4 Users
0 Reactions
6,847 Views
Posts: 167
 gb70
Topic starter
(@gb70)
Estimable Member
Joined: 6 years ago
[#55554]

Hi everyone,
I have a little problem that I can't understand.
I have an ESP32 with Espixelstick ... I have the first two outputs which check 500 pixels and d is all OK.
I would like to insert a third output for another 500 pixels (1500 pixels tot) ... but unfortunately nothing works anymore.

esp3out

if I carry over to the initial two outputs with 500x2 pixels ... everything works

is there by chance a pixel control limit by the ESP32?

I use vixen to control the effects

thank you
Graziano


22 Replies
Posts: 167
 gb70
Topic starter
(@gb70)
Estimable Member
Joined: 6 years ago

I did some tests, and I noticed that exceeding the total of 1000 pixels (on multiple outputs) the espixelstick gets confused and no longer connects to the router.
I assume 1000 pixels is the limit for the firmware to handle.

Do have you noticed this limit?


Reply
Posts: 339
(@heldwhat-christmas)
Reputable Member
Joined: 15 years ago

Which esp32 are you using? A few people on here have mentioned they are driving more than 1500 pixels so it shouldn't be an issue.
The d1 mini esp8266 (not an esp32) that comes with Shelby's pixelsticks I think have a limit around 900 pixels


Reply
Posts: 167
 gb70
Topic starter
(@gb70)
Estimable Member
Joined: 6 years ago

i have espWromm32 like this

ESP32 Pinout

I still tried ... but I can't go beyond 1000 pixels


Reply
Posts: 339
(@heldwhat-christmas)
Reputable Member
Joined: 15 years ago

what happens after you configure for more than 1000 pixels?

I just configured 3 outputs at 500 pixels each and each of the 3 outputs seems to work fine on my end


Reply
Page 1 / 5
Share: