And no V- sneak path. I was worried that the V- line does not have a fuse and that the V- line could get destroyed. Not so worried since I saw the fire analysis that showed it is difficult to get more than 5A through that interface anyway.
I also agree with your option 2. I did option 1 on my matrix in the beginning and had a lot of flickering issues. It was explained to me like this:
Think of it as 2 different circuits. V+ and V- go to complete a circuit to power the lights. Data and V- from the controller complete a circuit to control the circuit board in the light to turn them on. Data goes out the Data line and returns through the V-, (or vise versa). So the less obstacles (power distro, power supply, fuse, etc.) it runs into, the better.
Others here can get into the technicalities on how this works, or if it is even correct, but it made enough sense for me to avoid issues in the future. When I redesigned some of my pixel props, I now have a wire from the Data and V- to the first pixel every time, even if the controller is run off a different power supply. Which can turn into a whole other discussion, but always make sure all the V- are tied together.
You could also get away with just running two 2 conductor cables. 1st from the controller with Data and V- to the 1st pixel and the 2nd with V+ and V- from your distro to a tee between pixel 100 and 101. (This is assuming that the controller and Distro board are being powered by the same PS)
OK, I guess I had misunderstood a couple things.
So what would be the best way to do this with the least amount of cables needed? My control box is going to be approximately 20' from the closest pixel. The control box will be mounted in the closet then connects to wire trough (red box in pic). With all of the matrix's and lights I'm planning to use, this had me running 53 18-3 cables for V+ & V- & D, then another 51 18-3 cables for power injection only connected at the end of the 200 pixel strings, not using the data wire in that pi cable. If i need to run a separate V- wire from the controller i would need to run an additional 53 cables to the 1st pixel.
Believe me, i want to do this right the first time, i am not opposed to making changes now to make for a better installation. I am an electrician, so i can install whatever setup i need to. I just dont have the electronics backgrounds that some of you guys have. I understand the theory, but some of the stuff goes over my head.
Another option. Since the concensus is that i should run a Data AND V- from the controller, can i use the unused #18 wire in one of the 18-3 power injection only cables and use this for that controller V- wire? Or with it being run in the same multi-conductor cable as the power injection V+ and V- would that cause too much or any interference to not work?
I am changing course a bit to try to do it this way....not using V+ from controller, because that's what some of the more knowledgeable users have suggested. I was originally going to power everything from the controller and power inject at the end. And cut the V+ wire after pixel 50 or 100 so the controller doesn't have too many amps running thru it. I could then power inject the rest. Is that any better of a setup?
I'm starting to get a headache!
I understand most people use multiple control boxes at the various props. My thinking is that it would be simpler doing it in 1 big control box because they are all fairly close to eachother. Good, bad, better options?


