Activity
 
Notifications
Clear all
tbm878
@tbm878
Trusted Member
Joined: Dec 17, 2017
Topics: 9 / Replies: 28
Topic
Replies: 1
Views: 714
Reply
RE: Kulp K32 not outputting to lights

I have an early 2022 order from ww that I'm having problems with. All of the pixels worked fine after pushing them in the matrix's, but once hung on ...

3 years ago
Reply
RE: Kulp K32 not outputting to lights

I was able to get into the zoom room last night. They found some controller settings for me to change. I unchecked "auto upload configuration" and ...

3 years ago
Topic
Replies: 5
Views: 1320
Reply
RE: Whole house permanent pixels installed

davidtstewart wrote:Looks great! Did TrimLight do the installation or did you purchase the channels and put the LED's up yourself? (I didn't think t...

4 years ago
Forum
Reply
RE: New controller box setup

I did a power calculation to check which power injection method would work to give good voltage across all 800 pixels. I took Martin's past suggestio...

4 years ago
Reply
RE: New controller box setup

These tools helped with the installation.... Wire strippers to take the outer jacket off the 18-3 cables Klein wire strippers, worked really well t...

4 years ago
Reply
RE: New controller box setup

I started with a 4' x 8' x 1/4" sheet of black hdpe board that i bought from menards. I cut them down into smaller sizes with a table saw. I then us...

4 years ago
Topic
Replies: 3
Views: 1121
Reply
RE: Psu & fusing question

Yes, i am using 3 wire 120v power cords. Hot, neutral & ground wire.

4 years ago
Topic
Replies: 4
Views: 1535
Reply
RE: Increase voltage at psu

1pet2_9 wrote:If you set your injection point to be at 12V for all-off, then it will be below 12V for all-white. You're not going that far above 12V...

5 years ago
Reply
RE: Increase voltage at psu

Ok, that makes sense. I will check on the voltage rating of the pixels.

5 years ago
Reply
RE: Increase voltage at psu

MartinMueller2003 wrote:Find the max input voltage rating of the regulator your vendor used. There is no one answer to your question. Each regulator h...

5 years ago
Reply
RE: Increase voltage at psu

I would be using all regulated pixels. If i can increase the voltage at the psu for just the power injections i should be able to eliminate 1 extra p...

5 years ago
Page 1 / 3
Share: