Increase voltage at...
 
Notifications
Clear all

Increase voltage at psu

14 Posts
5 Users
0 Reactions
3,462 Views
Posts: 37
Topic starter
(@tbm878)
Trusted Member
Joined: 9 years ago
[#55564]

Is it safe to boost up the voltage on a meanwell 350 12v psu to say 13v or 13.5v to counter the effects of voltage drop on standard 18-3 xconnect extension cords? Meanwell's spec says it's output range is 10.2v to 13.8v. This would be with the controller powered by its own separate and smaller psu with only V- and D used there, and a separate isolated psu used only to power the pixel string & power inject that same string. I would adjust the voltage so it is at 12v at the start of the first pixel. And i plan to use all 12v regulated pixels.

Trying to figure out some options for some pixels that are about 30-40' wire length from the controller and minimize any extra cords.

Tim


13 Replies
Posts: 37
Topic starter
(@tbm878)
Trusted Member
Joined: 9 years ago

The output current would be affected....

12.0v & 29a
12.5v & 28a
13.0v & 26.9a
13.5v & 25.9a

I (current) = P (watts) ÷ E (volts)


Reply
Posts: 1420
(@1pet2-9)
Noble Member
Joined: 6 years ago

Generally, you can do more of that with regulated pixels than resistive. Your voltage drop should be all over the place, depending on whether you are all-white vs all-off. Try taking readings during a show and see. If you are only a little high like that, usually the first symptom is discoloration and more whiteness in the pixels. It's like overclocking your CPU:. you should be ok, but you assume the risk. Your risk of something running hot will be higher. I would just check for discoloration and hotness.


Reply
Posts: 37
Topic starter
(@tbm878)
Trusted Member
Joined: 9 years ago

I would be using all regulated pixels. If i can increase the voltage at the psu for just the power injections i should be able to eliminate 1 extra power injection cable. The only thing running "hotter" would be the extension cables. I would adjust the psu output voltage to 13 or so volts, so after the 35' distance of the power injection cable AT the first pixel it would be 12 volts.

I imagine it might affect the lifespan of the psu, but i dont think by much. It would be overclocked by about 10%.

Tim


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Find the max input voltage rating of the regulator your vendor used. There is no one answer to your question. Each regulator has a different max input rating. Keep in mind, that when the pixels are off, the regulator is converting that extra voltage to heat.


Reply
Page 1 / 3
Share: