Looking for a little clarification. After a lot of troubleshooting and reading I have managed to confuse myself. I was under the impression that the f...
Thanks for the birthday wishes. Sorry it took me so long to respond. God bless all
Excellent news! After many hours of frustration and an extensive troubleshooting process, I finally discovered the problem. There was a solder bridge...
Another point of interest, tried swapping Propellers between the V3 and Ethernode with the same result from the Ethernode.
Just out of interest, you have got the termination jumper on the ethernode as I assume it is the last board in the chain. Jumper installed on H5 and...
If the firmware isn't being loaded as Greg suggests, I had a problem with the microSD card. Try reformatting your SD card's and then reload the files....
Kiowamike, I have a weird thing to try. Put an ice cube in a baggie and hold it on the propeller chip and try to boot it. I had issues with the helix ...
If so, then the firmware isn't being loaded off of the microSD card during boot up. Could the EEPROM have been corrupted or dumped the firmware? If ...
If so, then the firmware isn't being loaded off of the microSD card during boot up. After a physical inspection of the board, the SD socket looks s...
If I'm understanding your description correctly, the heartbeat LED flashes on then off then back on and stays steady on. The stopped LED also comes on...
sACN doesn't like wifi. You shouldn't use sACN over a wireless segment of your network. It will likely work for a while with short tests, and small un...
Maybe it will help somebody else from going through the same thing It does help I am having similar problems. My set up is very similar 1 E1.31 Brid...
Good. What about your other files for the node sdcard ???? Sorry that was the ethernode the HNC is the same and it runs the test show on it no probl...
The config file is 2 KB and the firmware file is 32KB. I can open the config file in note pad and see data there.
From what I can tell all the SD cards have good data on them. My next thought is that the EEPROM that came with the ethernode is bad or corrupt. Can I...
