Helix Ether-Node Co...
 
Notifications
Clear all

Helix Ether-Node Controller

108 Posts
8 Users
0 Reactions
73.4 K Views
Posts: 300
(@kiowamike)
Reputable Member
Joined: 18 years ago
Good. What about your other files for the node sdcard ????

Sorry that was the ethernode the HNC is the same and it runs the test show on it no problem. the .seq files are anywhere from 20 to 40 kb on both cards.


Reply
Posts: 947
(@warlock)
Noble Member
Joined: 19 years ago

Ok. Can you communicate with the 2 units with the xbee ???? Also does your node play other files alright ????


Reply
Posts: 947
(@warlock)
Noble Member
Joined: 19 years ago

Also you can email Greg directly at greg@helinlightcontroller.com


Reply
Posts: 410
Topic starter
(@gmbartlett)
Honorable Member
Joined: 19 years ago
kiowamike wrote:I think at this point I'm at my wit's end. For some reason I can't get my Ethernode to connect to the NC. I have tried both wired and wireless communication and V3 and V2 main boards with no success.
my setup is as follows:
Network controller
Ether Node
E1.13 Bridge
Renard SS8 (for testing purposes. the final output will be to 10 REN PX1's)
I don't get any activity from the Ethernode. The heartbeat flashes and the stopped led illuminates. When using the wireless mode, the AI and TX LED's work as advertised. When the Ethernode is connected to the Bridge, the link and 100 light illuminate. I would appreciate any help from the group.

If I'm understanding your description correctly, the heartbeat LED flashes on then off then back on and stays steady on. The stopped LED also comes on. After this, then nothing else happens. Is this correct?

If so, then the firmware isn't being loaded off of the microSD card during boot up. I don't know why I didn't have the heartbeat LED flash in the SOS mode like the Helix main boards but this would have made this situation more obvious.

You can further test this theory by booting up the Ethernode without the microSD card installed and see if you get the same responses from the LEDs.


Reply
Posts: 373
(@blantrip)
Reputable Member
Joined: 16 years ago

Greg
What I notice is the heart beat led on the ethernode blinks normally until the sequence starts at which time it goes off. That led then resumes blinking during the pause between sequences and turns off again when the next sequence starts.


Reply
Page 19 / 22
Share: