If I'm understanding your description correctly, the heartbeat LED flashes on then off then back on and stays steady on. The stopped LED also comes on. After this, then nothing else happens. Is this correct?
That is correct.
You can further test this theory by booting up the Ethernode without the microSD card installed and see if you get the same responses from the LEDs.
I gave that a shot and it gave the same result. I even formatted both cards and swapped cards in boards. Both cards are known good cards. I used both of them last year in my hardware and like I said, the HNC plays a show off both cards.
If so, then the firmware isn't being loaded off of the microSD card during boot up.
After a physical inspection of the board, the SD socket looks secure and the resistor array looks secure as well with no solder bridges.
If so, then the firmware isn't being loaded off of the microSD card during boot up.
Could the EEPROM have been corrupted or dumped the firmware? If so could I get the right program to load into the Ethernode? It seems after all of my troubleshooting and comments from the group this may be my last option.
Kiowamike, I have a weird thing to try. Put an ice cube in a baggie and hold it on the propeller chip and try to boot it. I had issues with the helix last year and earlier this year from what Greg determined to be a change in the propeller chips. It would work perfectly when kept cool, but it would heat up and not boot unless cooled. He never found out what the issue was yet. Last year mine played fine with the case opened and a small fan blowing on it. If I closed the box, it would scramble the sd card and crash. I don't know if you have the same issue, but it wouldn't hurt to try. I ended up buying several propeller chips and finally found one that works fine.
Kiowamike, I have a weird thing to try. Put an ice cube in a baggie and hold it on the propeller chip and try to boot it. I had issues with the helix last year and earlier this year from what Greg determined to be a change in the propeller chips. It would work perfectly when kept cool, but it would heat up and not boot unless cooled. He never found out what the issue was yet. Last year mine played fine with the case opened and a small fan blowing on it. If I closed the box, it would scramble the sd card and crash. I don't know if you have the same issue, but it wouldn't hurt to try. I ended up buying several propeller chips and finally found one that works fine.
Interesting observation. Worth a try though.
