Helix Ether-Node Co...
 
Notifications
Clear all

Helix Ether-Node Controller

108 Posts
8 Users
0 Reactions
73.4 K Views
Posts: 373
(@blantrip)
Reputable Member
Joined: 16 years ago

If the firmware isn't being loaded as Greg suggests, I had a problem with the microSD card. Try reformatting your SD card's and then reload the files. I might also suggest trying a different SD card.


Reply
Posts: 300
(@kiowamike)
Reputable Member
Joined: 18 years ago
If the firmware isn't being loaded as Greg suggests, I had a problem with the microSD card. Try reformatting your SD card's and then reload the files. I might also suggest trying a different SD card.

I have already tried formatting both cards; and I used both cards last year in my V3 last year with no failures.


Reply
Posts: 31
(@cullen-ryan)
Eminent Member
Joined: 14 years ago

Just out of interest, you have got the termination jumper on the ethernode as I assume it is the last board in the chain.


Reply
Posts: 300
(@kiowamike)
Reputable Member
Joined: 18 years ago
Just out of interest, you have got the termination jumper on the ethernode as I assume it is the last board in the chain.

Jumper installed on H5 and on the right 2 pins of H3 andH4.


Reply
Posts: 300
(@kiowamike)
Reputable Member
Joined: 18 years ago

Another point of interest, tried swapping Propellers between the V3 and Ethernode with the same result from the Ethernode.


Reply
Page 21 / 22
Share: