jerry72
@jerry72
Guest
Member
Joined: Dec 29, 2013
Topics: 15 / Replies: 342
Reply
RE: Controll DMX controller from E682

angus40 wrote:Well , I hope you get success with resolving this today . Remember that copper is still King ! Well so far no success, the Green DMX ...

9 years ago
Reply
RE: Controll DMX controller from E682

Hopefully tonight I will have an answer as to how it all works. Because I am running esp modules, I switched over my pi to transmit multicast so I alr...

9 years ago
Reply
RE: Controll DMX controller from E682

pmiller wrote:Are you referring to another controller like a DMX Pro where "fixture" numbers have preset DMX starting channels? Sent from my SM-T710 ...

9 years ago
Reply
RE: Controll DMX controller from E682

pmiller wrote:You have 200 as the start address for only 30 channels. Change it to start address 1 and the next below that will be start address 31. ...

9 years ago
Reply
RE: E682 Pixel tree universe problems?

Wondering if he got it working.

9 years ago
Reply
RE: Controll DMX controller from E682

This is how i set mine up, i wish you could chose Renard and DMX at the same time, but can't, won't matter, next year, all my controllers, including t...

9 years ago
Reply
RE: Renard Plus WifiPixel HELP!?!?

fuxuepeng wrote:For this Thanksgiving I am thankful for Jerry72 who helped me finally figure out this headache. Sent from my iPhone using Tapatalk ...

9 years ago
Reply
RE: E682 Pixel tree universe problems?

Scarcebigfoot wrote:I adjusted all the color outputs based on LOR’s hardware control pixel test console. In this config the colors are all correct and...

9 years ago
Reply
RE: Renard Plus WifiPixel HELP!?!?

fuxuepeng wrote:Oh, I was holding the bulb backward when I took the photo. Here's a better picture. Still need to reverse? And from the other direc...

9 years ago
Reply
RE: Renard Plus WifiPixel HELP!?!?

If you are using Shelbys code, you may need to contact Renard directly, not sure Shelbys is supported on that controller.

9 years ago
Reply
RE: E682 Pixel tree universe problems?

You also need to make all your outputs RGB.

9 years ago
Reply
RE: Controll DMX controller from E682

jerry72 wrote:Yes, i just was unsure as to what wires were data and ground for DMX. I found this.....

9 years ago
Reply
RE: Controll DMX controller from E682

pmiller wrote:You can assign ports to DMX or Renard on a Sandevices 6804. It had only 4 ports. On the 682 you have to assign DMX or Renard in banks of...

9 years ago
Reply
RE: Controll DMX controller from E682

I found this as well, should be right, I hope.

9 years ago
Reply
RE: Controll DMX controller from E682

ezellner wrote:I believe, even with the new firmware, you can only designate by groups of four. For DMX or Rennard, use the J22 jumper set for a parti...

9 years ago
Page 3 / 25