Controll DMX contro...
 
Notifications
Clear all

Controll DMX controller from E682

69 Posts
5 Users
0 Reactions
24.1 K Views
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago
Reply
Posts: 357
Guest
Topic starter
(@jerry72)
Member
Joined: 13 years ago
pmiller wrote:If you're using Cat5e this is how I run Renard. The Orange and orange strip is Gnd. The solid blue wire is Clk and the blue stripe wire is DTA on the 682. You don't need to do anything on the other end of the Cat5e. Jumper J22 needs to be set for balanced output.

Sent from my SM-T710 using Tapatalk

Perfect, you dont happen to know what wire is what for DMX do ya? I got a 27 channel and a 30 channel i plan to run off the E682 as well.


Reply
Posts: 357
Guest
Topic starter
(@jerry72)
Member
Joined: 13 years ago
ezellner wrote:I believe, even with the new firmware, you can only designate by groups of four. For DMX or Rennard, use the J22 jumper set for a particular group. The connections for each type are shown in the E682 Operating Manual on the second to last page.

Jim did confirm that they have to be in blocks, all good. I can run my DMX and Renard controllers off it this year, next year everything but the 682 will be ESP8266.


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

Check the wiki link I posted.

dmx renard

Reply
Posts: 357
Guest
Topic starter
(@jerry72)
Member
Joined: 13 years ago

I found this as well, should be right, I hope.

RJ 45 PinoutA full

Reply
Page 2 / 14
Share: