Controll DMX contro...
 
Notifications
Clear all

Controll DMX controller from E682

69 Posts
5 Users
0 Reactions
24.1 K Views
Posts: 357
Guest
Topic starter
(@jerry72)
Reputable Member
Joined: 13 years ago

Works off Xlights as well. I will just leave the pi like that, all my ESP modules will be accessed for testing through xlights.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago
jerry72 wrote:I got it figured out, i will have to daisy chain the two controllers instead of having them on separate outputs that way i dont have to change my the channel outputs on my sequences. You can only run 1 universe from a single output, you can not use the same universe on different outputs. Once i ran 510 channels off one output, i got them working. Have not tsted it in Xlights, but it is all good. Oh and i dont have to run Pi in bridge to test the E682, it is hooked to a router as is the pi.

Way to go Jerry .

60 * atta boy's for your success and PMiller for sticking with it !

This was a good thread for my learning .

Thanks

Cheers


Reply
Posts: 357
Guest
Topic starter
(@jerry72)
Reputable Member
Joined: 13 years ago
angus40 wrote:Way to go Jerry .

60 * atta boy's for your success and PMiller for sticking with it !

This was a good thread for my learning .

Thanks

Cheers

What made me think of if was the DMX output on the Pi, it to has to be set at 510 channels, unlike the renard that can be set at whatever channel count ya have. This gets typed up and put in my binder.


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

Well heck. It only took 2 days and 70 posts. 🙂
Ooops! Ever since November 15.

Sent from my SM-T710 using Tapatalk


Reply
Page 14 / 14
Share: