Controll DMX contro...
 
Notifications
Clear all

Controll DMX controller from E682

69 Posts
5 Users
0 Reactions
24.1 K Views
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

try setting the e682 to 170 pixels for each dmx stand and save .

then you can pair your start channels as you like .

each stand should be its own universe of 510 channels provided you set each stand to 170 pixels as described in the opman.


Reply
Posts: 357
Guest
Topic starter
(@jerry72)
Member
Joined: 13 years ago
angus40 wrote:try setting the e682 to 170 pixels for each dmx strand and save .

then you can pair your start channels as you like .

each strand should be its own universe of 510 channels provided you set each strand to 170 pixels as described in the opman .

These controllers control dumb nodes, not pixels. They use standard DMX firmware.


Reply
Posts: 357
Guest
Topic starter
(@jerry72)
Member
Joined: 13 years ago
pmiller wrote:FPP uses fseg files that you export from you sequencing software. You can't send data to FPP at the same time FPP is running. I sequence using Vixen. If I have FPP running at the same time the lights are all messed up. When Vixen is launched it automatically starts sending data to the controllers unless I turn off the controller output in Vixen.

Sent from my SM-T710 using Tapatalk

I am trying to use the test mode on FPP to test the lights, tried it from Xlights as well.


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

FPP needs to be set in bridge mode to test from your sequencing software.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 357
Guest
Topic starter
(@jerry72)
Member
Joined: 13 years ago

I got it figured out, i will have to daisy chain the two controllers instead of having them on separate outputs that way i dont have to change my the channel outputs on my sequences. You can only run 1 universe from a single output, you can not use the same universe on different outputs. Once i ran 510 channels off one output, i got them working. Have not tsted it in Xlights, but it is all good. Oh and i dont have to run Pi in bridge to test the E682, it is hooked to a router as is the pi.

E682

Reply
Page 13 / 14
Share: