Controll DMX contro...
 
Notifications
Clear all

Controll DMX controller from E682

69 Posts
5 Users
0 Reactions
24.1 K Views
Posts: 357
Guest
Topic starter
(@jerry72)
Reputable Member
Joined: 13 years ago
pmiller wrote:Did you try and use the orange and brown wires for data and ground like it showed in a previous post?

Sent from my SM-T710 using Tapatalk

Yes, green light on the controller is blinking, so i am sure it is getting signal.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

How about the DMX controllers dip configurations , do that correlate with the e682 settings ?


Reply
Posts: 357
Guest
Topic starter
(@jerry72)
Reputable Member
Joined: 13 years ago

Here is my current setup, i have the dip switches set to channel 230 as well. I have tried putting the dip switch to channel 1 and the E682 to channel 1 but no joy. Tried giving the DMX there own universe as well, but still didn't work. I dont think this is an issue with the 682, again, green light is flashing on the controller. Tried running it all under unicast as well.

pi
E682
pi

Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

FPP isn't going to do much for you until you get the controller to output.

Sent from my SM-T710 using Tapatalk


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

FPP uses fseg files that you export from you sequencing software. You can't send data to FPP at the same time FPP is running. I sequence using Vixen. If I have FPP running at the same time the lights are all messed up. When Vixen is launched it automatically starts sending data to the controllers unless I turn off the controller output in Vixen.

Sent from my SM-T710 using Tapatalk


Reply
Page 12 / 14
Share: