Controll DMX contro...
 
Notifications
Clear all

Controll DMX controller from E682

69 Posts
5 Users
0 Reactions
24.1 K Views
Posts: 357
Guest
Topic starter
(@jerry72)
Member
Joined: 13 years ago
[#46992]

I have searched, bit can not find a diagram on how to hook a DMX controller up to an E682. I know i have to change the out put in the UI page, but i have no clue what wires going into the DMX controller mare data+, Data- and Ground. Also have no clue as to what wire goes into what connection on the E682.


68 Replies
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

If you're using Cat5e this is how I run Renard. The Orange and orange strip is Gnd. The solid blue wire is Clk and the blue stripe wire is DTA on the 682. You don't need to do anything on the other end of the Cat5e. Jumper J22 needs to be set for balanced output.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

Here is the documentation Jerry .


Reply
Posts: 357
Guest
Topic starter
(@jerry72)
Member
Joined: 13 years ago

I was under the impression that with the new firmware that you could assign dmx or renard to a single port now instead of the whole block


Reply
Posts: 740
(@ezellner)
Prominent Member
Joined: 11 years ago
jerry72 wrote:I was under the impression that with the new firmware that you could assign dmx or renard to a single port now instead of the whole block

I believe, even with the new firmware, you can only designate by groups of four. For DMX or Rennard, use the J22 jumper set for a particular group. The connections for each type are shown in the E682 Operating Manual on the second to last page.


Reply
Page 1 / 14
Share: