Controll DMX contro...
 
Notifications
Clear all

Controll DMX controller from E682

69 Posts
5 Users
0 Reactions
24.1 K Views
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

You can assign ports to DMX or Renard on a Sandevices 6804. It had only 4 ports. On the 682 you have to assign DMX or Renard in banks of 4 because jumper 22 is set up as such. However, I have not tested that yet.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 357
Guest
Topic starter
(@jerry72)
Member
Joined: 13 years ago
pmiller wrote:You can assign ports to DMX or Renard on a Sandevices 6804. It had only 4 ports. On the 682 you have to assign DMX or Renard in banks of 4 because jumper 22 is set up as such. However, I have not tested that yet.

Sent from my SM-T710 using Tapatalk

Yes, i just was unsure as to what wires were data and ground for DMX.


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago
jerry72 wrote:Yes, i just was unsure as to what wires were data and ground for DMX.

My post #9 shows DMX. Your post #9 is showing orange as data. Not too sure about that. Where did you get that?

Sent from my SM-T710 using Tapatalk


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

I just found this and even they use different colors wire for Renard and DMX.

F16v2* * * * * * * * * * * Renard
pin1 blue/white* * * * *pin 1 brown/white
pin 2 blue* * * * * * * * *pin 2 brown
pin 7 brown* * * * * * * pin 4 blue
pin 8 brown/white* * *pin 5 blue/white

So it appears it depends on what controller you're using and how that controller is setup for DMX and Renard.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 357
Guest
Topic starter
(@jerry72)
Member
Joined: 13 years ago
jerry72 wrote:Yes, i just was unsure as to what wires were data and ground for DMX.

I found this.....
http://www.pathwayconnect.com/index.php/support/reference-articles/27-pinout-standards-for-dmx-and-cat5


Reply
Page 3 / 14
Share: