angus40 wrote:That is very vague documentation for Renard and Renard DMX at best .
I do not see anywhere stating that no special firmware required .
No special firmware is required. I would check your Renard to make sure it works. There's no reason it shouldn't when it's connected to the 682
Sent from my SM-T710 using Tapatalk
Don't forget. When setting up the web page Renard needs to be on its own universe and always starting with channel 1. I made that mistake by putting pixels and Renard on the same universe.
Sent from my SM-T710 using Tapatalk
pmiller wrote:No special firmware is required. I would check your Renard to make sure it works. There's no reason it shouldn't when it's connected to the 682Sent from my SM-T710 using Tapatalk
Wouldn't regular Renard firmware be at 57600 baud though or 115000 ?
I had no issues running Renard dmx firmware with the e1.31 bridge .
I had thought the options were True DMX or Renard .
jerry72 wrote:This is how i set mine up, i wish you could chose Renard and DMX at the same time, but can't, won't matter, next year, all my controllers, including the DMX controllers will all be on ESP.
Shouldn't that start address be channel 1, not 200?
Sent from my SM-T710 using Tapatalk
You have 200 as the start address for only 30 channels. Change it to start address 1 and the next below that will be start address 31.
Sent from my SM-T710 using Tapatalk
pmiller wrote:You have 200 as the start address for only 30 channels. Change it to start address 1 and the next below that will be start address 31.Sent from my SM-T710 using Tapatalk
The reason i did that is because that is the start address i have set on those controllers. Or does that matter? i know when i ran them for Halloween off the dongle, i had to have them set like that.
jerry72 wrote:The reason i did that is because that is the start address i have set on those controllers. Or does that matter? i know when i ran them for Halloween off the dongle, i had to have them set like that.
If that's the controller that's going to run the lights then it needs to be set to 1. Try it. You're not using a dongle with the 682. Btw. What do you mean by "those controllers". The pics you posted are the controller. The 682 doesn't control another controller.
Sent from my SM-T710 using Tapatalk
Are you referring to another controller like a DMX Pro where "fixture" numbers have preset DMX starting channels?
Sent from my SM-T710 using Tapatalk
pmiller wrote:Are you referring to another controller like a DMX Pro where "fixture" numbers have preset DMX starting channels?Sent from my SM-T710 using Tapatalk
I have 27 and 30 channel dmx controllers that use dip switches, I will have those connected to the e682 instead of using the dongle which is unreliable. The 682 acts as the bridge, the controllers have to be set to start address, I was told to set the start address as well in the 682 so the 682 knows where to send the data
