I would take you up on that, but a lot of my wire is SPT-2. I've tried to cram it in and it's very difficult.
I just ordered some SPT-2 female vampire plugs from .. Cheapest price I could find anywhere accounting for shipping charges - $32 for 50 with free sh...
IaRoadKill wrote:I don't mean to hijack this thread but, I am having problems using the asm file to make a hex file using Mplabs program. I started a...
Stormyblade wrote:I have a quick question, after looking through all 40 pages of this thread, and it has to do with the above post. The code can be c...
dvc2013 wrote:I've used these things for 2-3 years with no problems at all. I buy them at our local gas station for about 65 cents. They have some t...
Good read here for understanding the basics, benefits and limitations of charlieplexing - Turns out that was exactly what it was. There were 3 LEDs ...
I have a question. When I run this on 5V without the resistors, I start to get some strange behavior with the lights. I was thinking, well I would j...
I was curious if anyone happened to know about the cheap knockoff A/C USB cubes like the ones that come with the iPhone. The one I have supplies 5V @...
So, I almost didn't post a reply here due to the nature of the mistake, but I figured if there's ever anyone else who comes across this same problem, ...
If I change both '56' values to '7', then LED #7 blinks off and on constantly with nothing else going on. I'll have to tinker around with it later to...
airsouth wrote:I'm using the one from the wiki with the 20110813 tag at the end, so I'm guessing it was Aug 13, 2011 (FAST_Snowfall_Tube_With_Tail_(Ra...
Heldwhat Christmas wrote:You have to change the 56 on both lines (it should be a couple lines above that one. Are you trying to do something customer ...
Heldwhat Christmas wrote:Is there a reason you are testing these on a bread board? I haven't looked at the code for a while but I don't remember it r...
I didn't see a forum area specifically for this device, but this is probably not the right area to post this either. So please forgive me if this pos...
Maybe that would be the way to go. I was just trying to work with what I mostly already had with the Renard SS controllers and use 3 of the output ch...
