Notifications
Clear all

WS2801 Pixel

14 Posts
9 Users
0 Reactions
8,723 Views
mrpackethead
Posts: 2289
(@mrpackethead)
Famed Member
Joined: 19 years ago

If you are prepared to destroy one, you'll be able to figure it out pretty simply with a multimeter and a data sheet. *typically theres a low value ( 33 - 300 ohm ) resistor on the output side, but again thats just 'typical'..


Reply
Posts: 95
(@cessnapilot)
Trusted Member
Joined: 18 years ago
thg wrote:Just want to make sure i have this correct before powering them up.

Red wire-DC5volts
White wire-Data
Green wire-Clock
Blue wire-Ground.

Thanks

Thomas

Are these the ones from the group buy at DIYLEDEXPRESS?

The ones i received have the input on the side the chip is on and colors as follows:
looking at the chip side, left to right
Red -- +5v
White -- SDO (Data)
Green -- CKO (Clock)
Blue -- GND

If you can see through the clear plastic on the back side (just resistors) they are labeled with the above labels. Also you will see above the +5v Red wire 4 arrows pointing down. I happened to have 1 pixel missing the silicon waterproofing, so the labels were easy to see.
"
Edit: You can't see any labels on the input side just the output side (no chip, just resistors) I am guessing the "O" at the end of SDO and CKO is output.


Reply
Posts: 68
 thg
Topic starter
(@thg)
Trusted Member
Joined: 17 years ago

Thanks everyone.
Yes these did come fromDIYexpress.
Wire them up just like I posted in #1 and cessnapilot confirmed the same thing also and they worked.
Now to figure out more on the 681s.
Thanks
Thomas


Reply
jklingert
Posts: 1767
(@jklingert)
Noble Member
Joined: 16 years ago

There are photos and details of typical pixel wiring schemes in the wiki


Reply
Page 2 / 2
Share: