Steven010 wrote:Propeller chip does not appear to connect to output pins, rather the 74HCT541 appears to. Likely this is part failing...OOPS! just looked at assembly manual for 6804, you are correct, appears to connect direct to Propeller chip. Same question applies, what happens to Propeller if 12V is applied to I/O pin????
\
Generally micros have a currently limiting and some type of shunt for over voltage. I am not that framilure with the propeller but on the atmega you can feed 120vAC into it as long as you don't go past the the current limit, atmel even has app notes on how to do this.
EDIT: i was wrong the prop is f 500μA(aka: 1/2 a milla amp) so that could be a serious issue. But anyways a fast 5v zener diod would be a good and cheap fix.
Steven010 wrote:BTW, it appears WorldSemi likes Ray Wu, he is mentioned repeatedly on Facebook site;I submit he could engage WorldSemi and get some proactive corrective action. Maybe even free design services.
I thought that first post looked interesting, they just stole the DIYC Wiki page.
I have to admit I have been slightly disappointed in my technicolors compared to my pixabulbs. I am kinda wondering if the lenses are contributing to the issues. I have them on 4 window frames with lenses and a arch without and have replaced bulbs in all the window frames but not the arch.... Hopefully I didn't just jinx myself.
Not having the DI and DO resistors makes that a possibility. I had Ray add them to the new board and that's been completed.


