Technicolor Pixels
 
Notifications
Clear all

Technicolor Pixels

140 Posts
31 Users
0 Reactions
43.4 K Views
Steven010
Posts: 416
(@steven010)
Honorable Member
Joined: 18 years ago

I would encourage Ray to perform the two tests I describe below; Apply 12V to data line repeatedly, 100 pixels sample size, 100 times, 0 failures. apply 5V to data line on up-powered pixel, 100 pixel sample size, 100 times, 0 failures.

timon wrote:Not having the DI and DO resistors makes that a possibility. I had Ray add them to the new board and that's been completed.

Reply
timon
Posts: 2149
Topic starter
(@timon)
Noble Member
Joined: 16 years ago

I'm going to have Ray send some of the new pixels without the case for some testing here.


Reply
Steven010
Posts: 416
(@steven010)
Honorable Member
Joined: 18 years ago

John,

Been testing some more, here are some more details for you;

Trying to stress data-in pin, so far no luck. So I turned to Thermal inspection. turned pixel to all bits high (full White) at 12.5V (worst case I can come up with), let run to 30 minutes.
The LDO was hottest point, reaching peaks of 70C (~158F) degrees. Never dropped out of regulation, never shut off. However, pretty hot. But I would think that being used outside in winter, the ambient temperature would work in its favor. Still not convinced we have root cause of failures....

Dropping voltage to 7V helps significantly with respect to temp...

Shown below is PCB and Thermal image...

THERM CLIP
PIXEL PCB CLIP

Reply
kingofkya
Posts: 2165
(@kingofkya)
Noble Member
Joined: 15 years ago

Another question worth asking is what power supplies are you guys useing, i have quite a few bad switcher power supplies (not from ray) that have 5-10v +- spikes to the voltage under light load that you cant see on a multimeater. Has any one checked any of the common power supplies with a scope?

What make me think this is that some of the other pixels use a shut regulates that is less efficient but its better to stop spikes.

Just thinking out load here.


Reply
Posts: 615
(@livinglightshows)
Prominent Member
Joined: 14 years ago

I am using the power supply from ray on my pixels that keep going bad. I have some technicolors on a PC power supply (converted) and have not had any problems. How can I protect against those spikes or even see if that is what occurring?

kingofkya wrote:Another question worth asking is what power supplies are you guys useing, i have quite a few bad switcher power supplies (not from ray) that have 5-10v +- spikes to the voltage under light load that you cant see on a multimeater. Has any one checked any of the common power supplies with a scope?

What make me think this is that some of the other pixels use a shut regulates that is less efficient but its better to stop spikes.

Just thinking out load here.


Reply
Page 24 / 28
Share: