e682 Distance Probl...
 
Notifications
Clear all

e682 Distance Problem?

18 Posts
10 Users
0 Reactions
4,410 Views
Posts: 615
Topic starter
(@livinglightshows)
Prominent Member
Joined: 14 years ago
[#28134]

I have an e682 where the strands were over 25-35 ft from the controller. The strands were having signal problems (pixels not responding, flicking, wrong colors, etc.) I replaced the resistor networks with 22 Ohm and then the test sequences ran perfect. However, when running a sequence from Vixen I am still having the signal problems, any know why or have insight into what to do?


17 Replies
Macrosill
Posts: 9739
(@macrosill)
Member
Joined: 19 years ago

I am guessing the cables are too long. You may need to add a null pixel in the middle to repeat the data signal to the string.


Reply
Posts: 46
(@zanclus)
Trusted Member
Joined: 14 years ago

I have a strand running from my E682 that is about 70' away . I added 4 null pixels at 16' intervals. The strand works peefectly.


Reply
mkozik1
Posts: 202
(@mkozik1)
Estimable Member
Joined: 15 years ago

Guys - Need to ask the stupid question of the day, but what is a null pixel? I am assuming that it is a repeater of sorts, but what does it look like? Where do I get one?

Thanks,


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
mkozik1 wrote:Guys - Need to ask the stupid question of the day, but what is a null pixel? I am assuming that it is a repeater of sorts, but what does it look like? Where do I get one?

Thanks,

It's just another pixel of the same type in your string and yes - it's a repeater. The E68x controllers can account for a number of them but they aren't counted in your addressing. So if you have a string of 50 plus an extra for the null - you still only work with the 50 at the sequencer level. It does not turn on, just juices up the line for next one.


Reply
Page 1 / 4
Share: