e682 Distance Probl...
 
Notifications
Clear all

e682 Distance Problem?

18 Posts
10 Users
0 Reactions
4,409 Views
mkozik1
Posts: 202
(@mkozik1)
Estimable Member
Joined: 15 years ago

Thanks Brian. So I have 6 windows, 5 of which have 50 pixels and 1 with 70. The furthest is 20' from the 682. Will this be an issue or will I need one of these null pixels? If so, you stated I would need another pixel of the same type and this one would not light up, but how do I tell a pixel it is a repeater and not to light up?


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
mkozik1 wrote:Thanks Brian. So I have 6 windows, 5 of which have 50 pixels and 1 with 70. The furthest is 20' from the 682. Will this be an issue or will I need one of these null pixels? If so, you stated I would need another pixel of the same type and this one would not light up, but how do I tell a pixel it is a repeater and not to light up?

20' *might* be an issue - there's no hard rule. As for how to set it up, it depends on your controller - The E68x (and probably J1Sys) have a setting for them on the configuration page.


Reply
Posts: 46
(@zanclus)
Trusted Member
Joined: 14 years ago

Mark- If you can get by with 69 pixels on your last strig just cut the last pixel off the strand of 70 and wire it about 15 ' from the controller to be safe. By doing this you can easily get 30 ' without issyes..


Reply
Posts: 1159
(@deonb)
Noble Member
Joined: 13 years ago
mkozik1 wrote:How do I tell a pixel it is a repeater and not to light up?

To be 100% clear - you don't do anything with the pixel for it not to light up. It's an ordinary pixel, complete with LED and everything. If you just stuck a controller on it in that state, it will light.

But, you tell the controller to simply not light the first 'n' pixels, however many you want.

Your sequencing software also doesn't know about these - just the controller.


Reply
Posts: 295
(@daytimer)
Reputable Member
Joined: 15 years ago
mkozik1 wrote:Thanks Brian. So I have 6 windows, 5 of which have 50 pixels and 1 with 70. The furthest is 20' from the 682. Will this be an issue or will I need one of these null pixels? If so, you stated I would need another pixel of the same type and this one would not light up, but how do I tell a pixel it is a repeater and not to light up?

First off, make sure you have the latest firmware in the 682. http://doityourselfchristmas.com/forums/showthread.php?29674-Strange-issue-with-E682-and-null-pixels&highlight=e682+firmware It is the .eeprom file in one of the posts in that thread. Follow the instructions on the web page and that will take care of that update.
The null pixel is selected toward the bottom of the 682 setup screen. You tell the controller which output number has the null pixel(s) and how many. In the screenshot, I have a null pixel on output 3-3, 3-4 and 4-1. I didn't have to do anything in Vixen for that. The controller just uses that to extend the signal.

682 setup

Reply
Page 2 / 4
Share: