Intro to pixels hel...
 
Notifications
Clear all

Intro to pixels help

201 Posts
30 Users
0 Reactions
47.7 K Views
dpitts
Posts: 1020
(@dpitts)
Noble Member
Joined: 16 years ago
AussieDoug wrote:It all depends on what forums you regularly visit. I spend most of my time on AusChristmasLighting (ACL) They tend not to spam the forums as they rely on there product doing the sales for them. Only time I have seen posts from them on any of the forums is when they release a new product or someone is asking them a question. I have bought a variety of controllers & have found there's the most stable & easy to use.

I do not believe Falcon spams the forums but we are here reading and participating everyday because we are just normal users like everyone else. Most products we give away for free like the Falcon Player. Do not hear you accusing us of spaming regarding the FPP but 95 percent of our posts are related to that. Maybe you are not a user of that product. As far as product selling itself I have yet to read a bad review and our users seem pretty satisfied.


Reply
Posts: 37
(@ltay13)
Eminent Member
Joined: 14 years ago

This thread seems to be getting a little heated, which it shouldn't be.

Let's be honest, both Falcon and Advatek (PixLite) controllers have great support available. PixLite controllers aren't discussed/supported on forums as much as Falcon boards. This is likely due to the fact that all Advatek users get direct support links when they purchase products. Therefore, most PixLite users would (and do) turn to Advatek support directly when they need it. Falcon users post on various forums for support because, that's where you get Falcon support from. There are so many forum members that the support on forums is also fast and very knowledgeable.

So either way, you're not going to have a problem getting good support on any of these products, considering how many options are available to get help.

By the way MindTrik, Advatek is more than willing to and often does call customers directly when they need phone support. Glad to hear Dave does too 🙂


Reply
Posts: 95
(@broomy111)
Estimable Member
Joined: 11 years ago

I have two Falcons and expansion board on order and I'm satisfied with my decision. 🙂 I'm getting into the pixel hobby this year and David was willing to assist me with a Sandevices controller issue. I think this hobby is great with so many folks willing to help out and transfer knowledge.

Sent from my iPad using Tapatalk


Reply
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

And the virtual string options Itay13?

Sent from my LG-H811 using Tapatalk


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago
MindTrik wrote:And the virtual string options Itay13?

Sent from my LG-H811 using Tapatalk

What is the deal with virtual strings ? Can you not afford real ones ? Lmao

Remember the fall from the high horse can be fatal !


Reply
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

The virtual strings save your rear end from the mistake you make.

Sent from my LG-H811 using Tapatalk


Reply
Posts: 486
(@uncledan)
Honorable Member
Joined: 11 years ago
MindTrik wrote:And the virtual string options Itay13?

Sent from my LG-H811 using Tapatalk

Both Falcon and Advatek offer a great product and great customer service. Both are here, both will call you on the phone(too many cell phone calls with Devo last year) and help you out. Different boards work better with different displays and personal preferences. For me the new Pixlite MKII is great. 1020 pixels per output is great with the layout of my home. Everything has pros and cons in life. The Virtual String option is nice as are many features of the Falcon board. That's why I plan on buying one to mix in with my Pixlites. Just be respectful and don't throw Advatek under the bus because they do offer GREAT product and GREAT customer support via posts here, email, chat on other forums and phone. I have never heard a bad thing about either Falcon or Advatek on any forum.


Reply
Posts: 58
(@mararunr)
Trusted Member
Joined: 13 years ago

Thought I would chime in on this thread as a user/owner of BOTH Pixlite and Falcon boards. Like some others, I started out with Pixlite boards (Pixlite 16 and a Pixlite 4). They were great boards for me at the time no doubt. The problem I ran into was not support, it was just capabilities. With Pixlite I was limited to one string type and a limited number of pixels per output (the second is being addressed by PixLite now I believe). So in an effort to address my struggles, I looked into the Falcon F16v2. It had multiple string type support and could handle way more pixels per output allowing me to run my display with less controllers. There were other benefits along the way that have just sweetened the pot for me like the fact that the interface is a basic webpage that I can access from any device (phone, tablet, computer, etc.) and as others have mentioned the built-in LCD display (not to mentioned getting 60+ feet to my first pixel WITHOUT a null pixel or pixel extender). Both Pixlite and Falcon are coming out with new capabilities again this year but for me, the Falcon still just edges out PixLite in areas I need capabilities. I mean the F16v2-R has an SD card slot directly on the board! I also understand the comments about loyalty as I have a neighbor that has run the same J1Sys controllers for multiple years. I just prefer to be on the bleeding edge and I think that's where Falcon chooses to be as well. You can look at this comparison chart and see yes, in raw pixel count, PixLite may edge out in their upcoming board, but in other categories like string type Falcon edges out. And yes, both Pixlite and Falcon stand behind their boards. I still use the Pixlites occasionally in my lab just for my own curiosity but my show is run on Falcon.
http://nutcracker123.com/nutcracker/rgb_controllers/


Reply
Posts: 246
Topic starter
(@gump2388)
Reputable Member
Joined: 16 years ago
mararunr wrote:Thought I would chime in on this thread as a user/owner of BOTH Pixlite and Falcon boards. Like some others, I started out with Pixlite boards (Pixlite 16 and a Pixlite 4). They were great boards for me at the time no doubt. The problem I ran into was not support, it was just capabilities. With Pixlite I was limited to one string type and a limited number of pixels per output (the second is being addressed by PixLite now I believe). So in an effort to address my struggles, I looked into the Falcon F16v2. It had multiple string type support and could handle way more pixels per output allowing me to run my display with less controllers. There were other benefits along the way that have just sweetened the pot for me like the fact that the interface is a basic webpage that I can access from any device (phone, tablet, computer, etc.) and as others have mentioned the built-in LCD display (not to mentioned getting 60+ feet to my first pixel WITHOUT a null pixel or pixel extender). Both Pixlite and Falcon are coming out with new capabilities again this year but for me, the Falcon still just edges out PixLite in areas I need capabilities. I mean the F16v2-R has an SD card slot directly on the board! I also understand the comments about loyalty as I have a neighbor that has run the same J1Sys controllers for multiple years. I just prefer to be on the bleeding edge and I think that's where Falcon chooses to be as well. You can look at this comparison chart and see yes, in raw pixel count, PixLite may edge out in their upcoming board, but in other categories like string type Falcon edges out. And yes, both Pixlite and Falcon stand behind their boards. I still use the Pixlites occasionally in my lab just for my own curiosity but my show is run on Falcon.
http://nutcracker123.com/nutcracker/rgb_controllers/

I def. didnt mean to start a heated debate over them for sure.
I really like the falcon based on the multiple types of pixels and nor all the same.

Btw do u have any plans for your mega trees?


Reply
MindTrik
Posts: 1542
(@mindtrik)
Noble Member
Joined: 16 years ago

You didn't...the issue here isn't loyalty..it's steering someone who doesn't have a board to simply...THE best option as of right now. You shouldn't regret a purchase after a purchase. Since you are just starting...you should just go ahead and get the best option. Also...don't forget the F16V2 has FOUR native DMX outputs on top of the string outputs. That's HUGE!

Sent from my LG-H811 using Tapatalk


Reply
Page 8 / 21
Share: