mararunr
@mararunr
Trusted Member
Joined: Dec 23, 2013
Topics: 10 / Replies: 48
Topic
Forum
Replies: 0
Views: 4995
Reply
RE: Modeling IcosaSphere?

That's my wiring diagram. You are welcome to wire it however you want and change the numbering to suit. Totally up to you. For most of us, just hav...

10 years ago
Reply
RE: Modeling IcosaSphere?

Here I am (Mark Valentine) :biggrin: and here you go :biggrin:

10 years ago
Reply
RE: Expo 2x2 P10 Matrix Sequence....

Wolfie wrote:Have yall put a meter or scope on the Vcc line to the BBB/Pi? I suspect that the voltage may be deviating based on pixel brightness. I ...

10 years ago
Forum
Reply
RE: Expo 2x2 P10 Matrix Sequence....

Word of caution if you are going to use wireless dongle - I would suggest two power supplies or at least two separate runs from your supply to the mat...

10 years ago
Forum
Reply
RE: Expo 2x2 P10 Matrix Sequence....

A couple of 5v wall plugs... For the BBB specifically...(this is barrel connector, can also use usb mini B connector type power supply) And for the ...

10 years ago
Forum
Reply
RE: Cause Ribbons by Boscoyo Studio

Back The Blue Cause Ribbon picture in picture video with RGB Floods...

10 years ago
Reply
RE: New IcosaStar Star and IcosaSphere from Boscoyo Studios

Star... Spheres (both sizes on same page)...

10 years ago
Reply
RE: Raspberry Pi 2 and no ws2811 support?

Wolfie wrote:Not beating a dead horse. Nothing wrong with chipping in info in case someone else following the thread has interest/need. BTW....CFOL?...

10 years ago
Reply
RE: Expo 2x2 P10 Matrix Sequence....

Here is a complete parts list with prices....$218.32 ($250.31 with battery pack) Four P10 Panels - $76.06 (delivered) BeagleBone Black (single boar...

10 years ago
Forum
Reply
RE: Raspberry Pi 2 and no ws2811 support?

dpitts wrote:Yeah. But that version has no buffer also. So what is considered "long term usage" - just trying to understand better. As you may reca...

10 years ago
Reply
RE: Cause Ribbons by Boscoyo Studio

Wolfie wrote:Thank you for helping with this. Is there a fast primer somewhere on connecting nodes direct to a Pi running FPP for a stand alone insta...

10 years ago
Reply
RE: WS2812B vs 2811

Yes, both use the same protocol for E1.31 data. The difference as listed in the other replys is the form factor - not the protocol. I have both on F...

10 years ago
Reply
RE: Raspberry Pi 2 and no ws2811 support?

No hat needed as shown in video. Could use Pi Zero as it's the same concept just different form factor (still has GPIOs just not pins but you could s...

10 years ago
Page 1 / 4